Johnboh
Active Member
My Journal is totally open for discussion. If you would like to chat it up or give me some pointers, tell me what I am doing right and wrong, I totally appreciate it. Thanks a bunch everyone!!!
This is my second attempt in this very small closet. First attempt resulted in 2 males and just poor room design.
This closet is a room within a room. I have a barn attached to my house. Years ago built a small room (6x10) within a large room 20x 16
Closet is 2x4 framed incased within 2"foam insulation board
Closet has two doors. one leading to my house the other leading to the barn in which this closet is housed.
Within that closet I built a 2'x2'x5' enclosure, this is where the grow will take place. Its located in the far corner of the closet. right next to the eve of my roof.
Enclosure is painted top to bottom with one coat of kilz latex primer
then 2 coats of kilz white latex matte finish
I wired the room up with its own 15amp breaker. 2 gfci outlets in a series. both outlets have exterior h20 proof housings
1 70 cfm bathroom exhaust fan mounted in the center of the ceiling of the room - exhausted out of the room via 4" ducting totaling about 3.5' ducting to reach the outside of the room.
At the end of the ductiing I installed a carbon scrubber I made out of
4" ducting
Gorilla tape
Activated Carbon
green scrubby cloth
I wrapped the small piece of ducting with gorilla tape to make it stronger, then i taped on piece of scrubby cloth on one end of the ducting.
then i filled it with carbon,put another piece of scrubby on the other end and taped it down.
once I did that I taped it to a painters cup with the bottom cut off, this is acting as a reducer flange so I can fit the scrubber right into the exhaust ducting.
This is my second attempt in this very small closet. First attempt resulted in 2 males and just poor room design.
This closet is a room within a room. I have a barn attached to my house. Years ago built a small room (6x10) within a large room 20x 16
Closet is 2x4 framed incased within 2"foam insulation board
Closet has two doors. one leading to my house the other leading to the barn in which this closet is housed.
Within that closet I built a 2'x2'x5' enclosure, this is where the grow will take place. Its located in the far corner of the closet. right next to the eve of my roof.
Enclosure is painted top to bottom with one coat of kilz latex primer
then 2 coats of kilz white latex matte finish
I wired the room up with its own 15amp breaker. 2 gfci outlets in a series. both outlets have exterior h20 proof housings
1 70 cfm bathroom exhaust fan mounted in the center of the ceiling of the room - exhausted out of the room via 4" ducting totaling about 3.5' ducting to reach the outside of the room.
At the end of the ductiing I installed a carbon scrubber I made out of
4" ducting
Gorilla tape
Activated Carbon
green scrubby cloth
I wrapped the small piece of ducting with gorilla tape to make it stronger, then i taped on piece of scrubby cloth on one end of the ducting.
then i filled it with carbon,put another piece of scrubby on the other end and taped it down.
once I did that I taped it to a painters cup with the bottom cut off, this is acting as a reducer flange so I can fit the scrubber right into the exhaust ducting.