It's not dead yet - it's still green.
Stick something in the ground like a pencil or a bamboo skewer and tie a little string to stand that little fucker up.
Get more lights as well, and get them as close to the plant as possible if you're using CFLs they should be about 1-2" from the plant.
i've a 250mh at about 10" in a very smal tent 40*40*120cm , the temperatures are high so i think i better not put the ligh closer to the plants
I'll get something to make it stand, thanks.
move light away a liitle about 20" stake her up and the soil looks really dry m8 give it a gd misting. bet that helps let us know, did u soak the pot before planting?
well if others ok jus stake her up, personally i always keep seedlings misted, but make sure light not 2 close to burn. give her a little water m8 she be fine, a small oscilting fan will help to strengthen her up,
well if others ok jus stake her up, personally i always keep seedlings misted, but make sure light not 2 close to burn. give her a little water m8 she be fine, a small oscilting fan will help to strengthen her up,
just toppled over its own weight, keep in mind these are like real babies, very delicate. I lost about half my crop because of these babies falling over and drying up, on a side note my best plant this summer was a plant that i saved after it toppled over. Just make sure u keep it up strain with something and get those lights as close as possible, most of the time they topple over because they are growing to tall for the size(stretching).
Don't think that's the case Bigol'Bong, the plant is about .8 inches tall (~2cm). It-s most likely the temperature, but she-s standing up now and i-ve just put diamon reflective sheeting all over the place haha. Thanks
You don't need reflection you need to lower your temps
No matter how much reflective shit you put on the walls the temps will still be too high to give you the harvest you are looking for
At 85°F the growth and bud production is slowed unless you are adding co2 at like 1500 ppm which I doubt
84 CFM? Are you serious? Are you thinking of 84.5m3/h?
I used a 306 CFM inline fan on my 250 watt HPS air cooled and temps were still a bitch to keep under control