nitro harley
Well-Known Member
I am shareing this method....because it works so good...and cost so little...I have had a 100% success rate...
You need 1 bucket and a lid like the one in the pictures....and a pump I use a ECO264 and I leave the fillter on the pump so roots don't get sucked up into the pump...the pump cost 22.00..
The hole saw for the pucks is a 1 5/8"
The hole saw for the drain and fill is a 22mm
It didn't take me five minutes to drill holes...set the pump in the middle of the bucket and run the power cord thru one of the pucks...
you are ready for cuttings and water...it's that simple...
If one of the pucks leak it drains into those pockets around the outside of the lid...and I just poke a little pin hole thru the lid in one of those pockets and it drains back into the bucket...
The lid snaps on pretty tight The hole near the bottom of the bucket is the drain and fill..I use a pump to refill with nutes that way you don't have to take the lid off...I will post pics...
You need 1 bucket and a lid like the one in the pictures....and a pump I use a ECO264 and I leave the fillter on the pump so roots don't get sucked up into the pump...the pump cost 22.00..
The hole saw for the pucks is a 1 5/8"
The hole saw for the drain and fill is a 22mm
It didn't take me five minutes to drill holes...set the pump in the middle of the bucket and run the power cord thru one of the pucks...
you are ready for cuttings and water...it's that simple...
If one of the pucks leak it drains into those pockets around the outside of the lid...and I just poke a little pin hole thru the lid in one of those pockets and it drains back into the bucket...
The lid snaps on pretty tight The hole near the bottom of the bucket is the drain and fill..I use a pump to refill with nutes that way you don't have to take the lid off...I will post pics...
