Cyooler
Active Member
Okay so I was smokin one day back in FL about 6 months ago with a friend and she up and drops my glass pipe right after I packed the second bowl...
Obviously I was upset but was more interested in taking in some more Blueberry Skunk. So I went MacGyver and made a gravity bong in about 5 minutes with stuff everyone has in their home.
Supplies:
- 2 liter plastic bottle (Coke, Pepsi, etc.)
- 1 thoroughly cleaned bucket or container (about as tall as the plastic bottle)
- Aluminum Foil
- Toothpick
- Knife / Scissors
- Water (duh)
Start by cutting the very bottom of the plastic bottle at its widest point.
Then very carefully cut a hole through the top of the plastic cap of the bottle. Make sure you don't cut into the screw thread of the cap.
Use a small piece of aluminum foil and wrap the plastic bottle cap from the top, around, and under by the screw thread of the bottle cap.
Use a toothpick to prick small holes through the aluminum foil on the top of the bottle cap. *Make sure you don't rip the aluminum foil or make the holes too big or your bud will get sucked through the bong into the water*
Then lightly screw the cap onto the plastic bottle. *1 or 2 turns should seal it*
Fill your bucket with water.
Now submerge the plastic bottle in the water bucket until only the neck of the plastic bottle is above water. *Don't get the cap and aluminum foil wet*
Finally pack a small amount of bud in the center of the aluminum foil.
Take a lighter and light the bud while slowly pulling the bottle out of the water vertically. *Do not pull the bottle completely out of the water or else the smoke will escape through the big hole you cut at the bottom of the bottle*
Unscrew the cap and suck in the beautiful big hit...
I'm sure almost everyone has tried this but just the same it is one easy and smooth way to smoke if you don't have papers or a pipe.
Enjoy
Obviously I was upset but was more interested in taking in some more Blueberry Skunk. So I went MacGyver and made a gravity bong in about 5 minutes with stuff everyone has in their home.
Supplies:
- 2 liter plastic bottle (Coke, Pepsi, etc.)
- 1 thoroughly cleaned bucket or container (about as tall as the plastic bottle)
- Aluminum Foil
- Toothpick
- Knife / Scissors
- Water (duh)
Start by cutting the very bottom of the plastic bottle at its widest point.
Then very carefully cut a hole through the top of the plastic cap of the bottle. Make sure you don't cut into the screw thread of the cap.
Use a small piece of aluminum foil and wrap the plastic bottle cap from the top, around, and under by the screw thread of the bottle cap.
Use a toothpick to prick small holes through the aluminum foil on the top of the bottle cap. *Make sure you don't rip the aluminum foil or make the holes too big or your bud will get sucked through the bong into the water*
Then lightly screw the cap onto the plastic bottle. *1 or 2 turns should seal it*
Fill your bucket with water.
Now submerge the plastic bottle in the water bucket until only the neck of the plastic bottle is above water. *Don't get the cap and aluminum foil wet*
Finally pack a small amount of bud in the center of the aluminum foil.
Take a lighter and light the bud while slowly pulling the bottle out of the water vertically. *Do not pull the bottle completely out of the water or else the smoke will escape through the big hole you cut at the bottom of the bottle*
Unscrew the cap and suck in the beautiful big hit...
I'm sure almost everyone has tried this but just the same it is one easy and smooth way to smoke if you don't have papers or a pipe.
Enjoy