Aero Help Plants sagging!

So I transplanted 10 Platinum OG Kush clones from Coco to My aero setup yesterday mixed up my Advanced nutes Mother sweet tea to 900 ppm using filtered bottle water. pH set at 5.5. My res temp has been between 60-70. Plants seemed to take before i went to bed (3-4 hrs later) no sagging happening then. this morning readings look good pH at 5.5, 900ppm, res at 65 and they where sagging the bigger ones are worse as if they where being over watered. plants haven't lost any color and have no signs of nute burn. Curious if the plants are just in shock from having them in coco to root more after they came out of the cloner(this is the medium the grower uses where got the clones)? any suggestions what to do to get them revived or if its just some stress. I have set the pump timer to off 10 min on 1 min to see if they perk back up. any advice will help might scrap these 10 and get 10 straight from the cloner but want to get these going if possible still first.

This is just my opinion, but 900 ppm is way too high for the first week of transplant into aero. I would flush your res and run pure water for 24 hours. Then re-add nutes to a ppm of 200 to 400 for the first week, then start to up your nutes. Also, keep your lights, if Hps or Mh about 30 inches away for a few days.
Again, just my opinion.

I think hidden dragon is right. I dont think you need to use high nute concentrations b/c the plants uptake them better in aero. the highest ppm I reach is about 600-800. just my 2 cents