Any ideas?

RootDoktor · Jul 11, 2020

Whats going off here then guys,

BobThe420Builder · Jul 11, 2020

It's a baby

Give it time

RootDoktor · Jul 11, 2020

BobThe420Builder said:
It's a baby

Give it time

Normal marks on the leafs ? I'm just trying to get off to a good start and keep on top of any problems

lime73 · Jul 11, 2020

Need to know way more info like, medium, water your using, ph ppm/ec? Temp humidity, led watt, distance, etc etc...
More info about your grow the better we can assist.

RootDoktor · Jul 11, 2020

lime73 said:
Need to know way more info like, medium, water your using, ph ppm/ec? Temp humidity, led watt, distance, etc etc...
More info about your grow the better we can assist.

Cool well their currently under a very cheap LED strip no more than 25w top of leafs are quite close to the light to be honest ? Could it be slight light burn ? and sat on a heat mat . The temp of the area is 24° ,its growing in biobizz light and started in a rootriot, iv only watered with water rhizotonic and canna start is this too much for early seedlings ? Ph is 6.2 at the minute

Any help or advice would be great

TropiKanna · Jul 11, 2020

RootDoktor said:
Cool well their currently under a very cheap LED strip no more than 25w top of leafs are quite close to the light to be honest ? Could it be slight light burn ? and sat on a heat mat . The temp of the area is 24° ,its growing in biobizz light and started in a rootriot, iv only watered with water rhizotonic and canna start is this too much for early seedlings ? Ph is 6.2 at the minute

Any help or advice would be great

Never give nutrients until at least the second week while in the seedling stage. And when you do start feeding only feed with a 1/4 of the recommended strength and move up from there...

lime73 · Jul 11, 2020

How close is it to light?
Led can be to intense at close range, I'd back it of a bit and see if it helps, leaf will always be damaged now, just watch that it doesnt get worse.
What kind of water you using?

RootDoktor · Jul 11, 2020

TropiKanna said:
Never give nutrients until at least the second week while in the seedling stage. And when you do start feeding only feed with a 1/4 of the recommended strength and move up from there...

OK cheers man, I'll give this a shot

Couchland · Jul 11, 2020

Slightly burnt from being too close to the light. I see it all the time. Barely hurts them. Shouldn't be an issue for you.

RootDoktor · Jul 11, 2020

lime73 said:
How close is it to light?
Led can be to intense at close range, I'd back it of a bit and see if it helps, leaf will always be damaged now, just watch that it doesnt get worse.
What kind of water you using?

Its not an ideal set up really its rather close ill try moving away a little bit and just tap water with riz and canna start ph 6.2. Thanks dude

RootDoktor · Jul 11, 2020

Couchland said:
Slightly burnt from being too close to the light. I see it all the time. Barely hurts them. Shouldn't be an issue for you.

Chees brother . Thats what I was hoping to hear lol reassurance . Nice one

RootDoktor · Jul 12, 2020

Couchland said:
Slightly burnt from being too close to the light. I see it all the time. Barely hurts them. Shouldn't be an issue for you.

If i was to put these in the tent under 600w hps . What sort of distance should I use

Couchland · Jul 12, 2020

As far as possible until they're grown up a bit, 3-4 feet for now. 1.5-2 feet for more mature, raging plants.
I'm assuming you are cooling that effectively?

RootDoktor · Jul 13, 2020

Couchland said:
As far as possible until they're grown up a bit, 3-4 feet for now. 1.5-2 feet for more mature, raging plants.
I'm assuming you are cooling that effectively?

Yea 2 decent fans and the extracter is pulling hit air out constantly all vents open, it sits at around 25 26 can get upto 28 30 on a very hot day ,, not much I can do about that at the minute

Buddernugs · Jul 13, 2020

Do yourself a favor get a mars hydro ts 600 or ts 1000 Bill Ward on YouTube uses them exclusively now (ts and best series of mars Hydro) and pulled 8oz of one autoflower grown under 1 ts1000 start to finish not bad for 150w

Buddernugs · Jul 13, 2020

For what your getting their dirt cheap

spek9 · Jul 13, 2020

Buddernugs said:
Do yourself a favor get a mars hydro ts 600 or ts 1000 Bill Ward on YouTube uses them exclusively now (ts and best series of mars Hydro) and pulled 8oz of one autoflower grown under 1 ts1000 start to finish not bad for 150w

A half pound from a single auto-flowering plant under 150W?

This is my first year growing autos, but what I've been told by auto breeders, that seems like a miraculous feat. Almost too good to be true.

It'd be a stretch to get 8 oz from a photo even after a long veg under 150W.

RootDoktor · Jul 13, 2020

spek9 said:
A half pound from a single auto-flowering plant under 150W?

This is my first year growing autos, but what I've been told by auto breeders, that seems like a miraculous feat. Almost too good to be true.

It'd be a stretch to get 8 oz from a photo even after a long veg under 150W.

Sounds like a sales pitch to me ,, but who am I to judge im gonna stick with my hps 600w with dimmerble option to 1000w though I think

Couchland · Jul 13, 2020

RootDoktor said:
Yea 2 decent fans and the extracter is pulling hit air out constantly all vents open, it sits at around 25 26 can get upto 28 30 on a very hot day ,, not much I can do about that at the minute

Pushing it a bit but totally doable. Just don't overdo anything else.

Skewbong · Jul 13, 2020

spek9 said:
A half pound from a single auto-flowering plant under 150W?

This is my first year growing autos, but what I've been told by auto breeders, that seems like a miraculous feat. Almost too good to be true.

It'd be a stretch to get 8 oz from a photo even after a long veg under 150W.

I saw the video too. Hes awesome. He's rocking that light...but he's very experienced too. I love my mars tsw 2000 (308 watts). I pulled 13 zips and found out one of my drivers was only at about 75%... its fixed now 8-)

Any ideas?

Active Member

Attachments

Well-Known Member

Active Member

Weed Modifier

Active Member

Well-Known Member

Weed Modifier

Active Member

Well-Known Member

Active Member

Active Member

Active Member

Well-Known Member

Active Member

Well-Known Member

Well-Known Member

Well-Known Member

Active Member

Well-Known Member

Well-Known Member