BK’s shit show

Status
Not open for further replies.

Markshomegrown

Well-Known Member
I’d say I’m doing pretty damn good if a master like you could only circle 6 leaves out of thousands. Can we address your super cupped leaves and serrated edges now?
I am growing under HPS, using a large fan, aimed between the hood and the canopy to move the heat away from the canopy and keep the temps in check, results are "mild wind burn" not much i can do about this, causes mild stress to the plants.
 

Nizza

Well-Known Member
Ever seen these gadgets to help dial in moisture/ soil salinity? I bought one but I've been so off on my grow op lately just slacking but wondering if you've seen this or thought about adding it to your tools. I plan to use it more when my manifold system is balanced better and blah blah blah

I don't know if this is a reliable site but it is a bluelab pulse. It measured moisture content and soil/medium PPM

The only thing I don't understand with it is there is no calibrations or cleaners that I can see recommended
I wasn't getting enough runoff one grow and sure enough one of the plants that wasn't drinking had a very high PPM cause it was fed like the rest and was a light feeder. Since little runoff the ppm was super high
 

bk78

Well-Known Member
Ever seen these gadgets to help dial in moisture/ soil salinity? I bought one but I've been so off on my grow op lately just slacking but wondering if you've seen this or thought about adding it to your tools. I plan to use it more when my manifold system is balanced better and blah blah blah

I don't know if this is a reliable site but it is a bluelab pulse. It measured moisture content and soil/medium PPM

The only thing I don't understand with it is there is no calibrations or cleaners that I can see recommended
I wasn't getting enough runoff one grow and sure enough one of the plants that wasn't drinking had a very high PPM cause it was fed like the rest and was a light feeder. Since little runoff the ppm was super high
I think it would be a handy gadget to own.
 

bk78

Well-Known Member
So with the weather outside gone to complete shit, it’s time to start adding heat at nights in my room

I have a oil heater hooked up to a inkbird controller to add the heat during lights out. Lights on temps are pretty low too but I refuse to run a heater during lights on.

The last week of data gathered from the pulse.

88C10E79-2CFD-45AE-B5BC-D50611735339.jpeg





FD8EFA52-E7A8-4958-9AA9-815DDA348BA4.jpeg
 
Status
Not open for further replies.
Top