Clones to Hempy Bucket with Fish Media

This is just a small little journal to see if I can get well supported roots ready for Hempy in an aero cloner.
I always found I had better luck and cloned faster in aero versus rockwool. Rockwool would probably choke the clones out if used in an
aero cloner, so I figured I would try some fish filter media I had laying around.

This is a course PP fiber that should allow lots of oxygen to the plant and support just as well as rockwool.
The finer grade media would probably work well in propagation trays. If this works out well it might be a decent media option.
The large bulk rolls used in koi pounds would be a fraction of the cost of rockwool.

I used a DIY ezcloner to start mine and had to veg a couple extra weeks due to some root damage I initiated during xplant. Very good system I think, had to separate the root systems (which got huge whilst on vacation) just keep an eye on them and xplant sooner than later

I'm just about done. I needed to restart the cloning process because my pump died while I was on a jobsite for a few days.