Cutter Electronics: Complete DIY COB kits

welight

welight

Well-Known Member
OrganicGro said:
Thanks for the quick reply Mark. Forgive the stupid questions, do I need anything extra that's not in the 5 kit to run at 50w per cob?

Thanks again
Click to expand...
only your basic hardware, wire, terminations etc, we will be adding this to kits once we have stock
Cheers
Mark
 
Humble grower

Humble grower

Well-Known Member
With the dimmer switch I hooked up the purple wire to the positive and the Grey wire to the negative then I just capped the yellow. It doesn't draw the full 217-220 on my kilo-watt anymore it's like 195ish (that's on 1 driver) but I won't be running full out anyway
 
Humble grower

Humble grower

Well-Known Member
I Googled how to ground your diy led light and found a few links I'm going to read up on before I put it up and start running it as well as have an electrician look it over and double check my work just to be on the safe side.
 
welight

welight

Well-Known Member
Humble grower said:
I Googled how to ground your diy led light and found a few links I'm going to read up on before I put it up and start running it as well as have an electrician look it over and double check my work just to be on the safe side.
Click to expand...
always a safe option
Cheers
Mark
 
A

akaki

Well-Known Member
nogod_ said:
@welight 1070?
:wink:
Click to expand...
Also gg sinks made from 1070 I don't know if they have the same supplier...
So same alloy , a bit bigger surface area than the 120 mm heatsinks which is 50 watt rated .
Did I missing something?
Is it any other reason that those sinks should not work well for my setup?
 
You must log in or register to reply here.
Top