CellarDweller
Well-Known Member
and to think there are people here that would troll your thread
CXA3590 Build Plan
- Thread starter Doer
- Start date
bicit
Well-Known Member
I think the first part of this thread was mostly due to a breakdown in communication with a dash of troll. Once insults started to fly it turned into a fluster cluck.and to think there are people here that would troll your thread
Doer
Well-Known Member
Go figure.and to think there are people here that would troll your thread
Doer
Well-Known Member
I seem to be the only one that had fun?
Fluster cluck is fun. Someone swooped in out of nowhere with vengeance about Cree jokes from another thread. He wrote a very heartwarming satire. That was fun...but I didn't read it.
Doer
Well-Known Member
Well, as much as I like the bathroom for a workshop I can't get the torque holding with my little suction cup vise. I am finally getting out of this hotel at the end of the month. I need to set up a bench vise, but this will work fine.
Hey! I didn't know RIU has mouse drag on photo uploading. Very cool.
Hey! I didn't know RIU has mouse drag on photo uploading. Very cool.
AquariusPanta
Well-Known Member
Also a fun fact about RIU, you can reply to multiple comments within the structure of creating one response. People love it.
Doer
Well-Known Member
Good question answer no.
When I got the holders I realized I had the great opportunity to not drill in the water channel but to use the 1/4" sides to tap a hole in.
But this will make the COBs at 45 degrees, not square so a different tape mask concept will be needed.
heckler73
Well-Known Member
Acetone is your friend...and so is a heat gun (my favourite method for softening adhesives).
Maybe not at the same time, however
http://www.doityourself.com/stry/how-to-remove-old-painters-tape