DIY flood tray

AngryMexican

Active Member
I made a flood table from plastic, cos no local hydro shop sells the size I need (4x8ft). Made it hermetic etc... It can hold over 100 litres.
Never used such thing, so now trying to figure out how usually do I need to empty it from the runoff water? So that the infection does not have enough time to develop? I water about 40 litres a day till it drain about 20%

Pots itself stands on a plastic platform (3 inches above the bottom of tray)

 
Last edited:

xtsho

Well-Known Member
You're not doing what's referred to as flood and drain which would require pumps, a reservoir, a method for oxygenating the nutrient solution, etc... You're doing a standard watering to runoff and capturing that runoff to discard later by removing it with a shop vac. Basically a manual drain to waste setup without a drain.

You do not want those plants sitting in that stagnant nutrient solution for any amount of time.
 

AngryMexican

Active Member
You're not doing what's referred to as flood and drain which would require pumps, a reservoir, a method for oxygenating the nutrient solution, etc... You're doing a standard watering to runoff and capturing that runoff to discard later by removing it with a shop vac. Basically a manual drain to waste setup without a drain.

You do not want those plants sitting in that stagnant nutrient solution for any amount of time.
But pots are lifted, so they don't touch the excess nutrient solution, I am emptying it once a week, hopefully I dont get any mold...
 
Last edited:
Top