boostedhonda
Well-Known Member
will this pot work for a single hlg 185h c700b?
diy led cob bar potentiometer
- Thread starter boostedhonda
- Start date
Greengenes707
Well-Known Member
yes
boostedhonda
Well-Known Member
can i run the driver with no pot attached
Last edited:
thetr33man
Well-Known Member
Yes, it will just run at full power then.
boostedhonda
Well-Known Member
maybe a dumb question but how do i hook it up? i tried hooking a dimming wire to each side of the pot and it had no effect
Zulunature
Well-Known Member
One wire to the middle pin and one to either the left or right pin (this will determine clock or anti clockwise rotation of knob increasing or decreasing output)... sorry can't recall which does what...
Negative (black) to the outside...
Oh and add a resistor to the negative side of 10K so that it doesn't go below 10% output as recommended by Meanwell and increases the output of the Pot. at the top end as most only go to 90-96K with the 10K in series you should get the maximum 100K output.
Negative (black) to the outside...
Oh and add a resistor to the negative side of 10K so that it doesn't go below 10% output as recommended by Meanwell and increases the output of the Pot. at the top end as most only go to 90-96K with the 10K in series you should get the maximum 100K output.
Airwalker16
Well-Known Member
ADD THE RESISTOR. Doesn't matter what size.go with 1/2 watt to keep it simple.also, if a 10k resistor isn't available, any number of other resistors that will Ultimately equal "10" or close to, will also work. (3-3.3's, 2-5's, 4-2.5's etc....)
Airwalker16
Well-Known Member
Like this bro,
brettsog
Well-Known Member
Please heatshrink that resistor.
Airwalker16
Well-Known Member
No. You're not supposed to.
heat, but in this case low voltage dimming circuit not an issue.
boostedhonda
Well-Known Member
thanks fpr the quick replies, so 1/2w 10k resistor? i dont know much about this stuff...is there any chance i could have messed up the driver by connecting dimming leads to outside post on pot?
Airwalker16
Well-Known Member
No you're fine. Just hook it up right with the resistor
boostedhonda
Well-Known Member
ok cool thanks, i plan to run a 200w bar (4 72v 3590s at 700ma) and i want to run this in a 20"x36"x60" tent, i get a gram a watt in coco hempys with a premade apollo400w and apollo300w panel (pull around 280 at the plug), how would this light compare to my previous setup?
Similar threads
