donThomaso
New Member
do i need closed loop to remove mystery oil or can it be done after blasting?
do i need closed loop to remove mystery oil?
- Thread starter donThomaso
- Start date
donThomaso
New Member
Ok, can I remove it with out closed loop?
TokeTokerson
Member
To my best knowledge you would use a closed loop system to remove mystery oil. I don't think you would find something cheaper to remove it if that's what you were asking. Although it doesn't have to be some extremely expensive setup if you're just using it to remove the mystery oil.
Fadedawg
Well-Known Member
VICI Metronics makes filters for removing it. We used their filters after pre-distillation, to further polish our LPG, but they can also configure filters for gross removal.
Try [email protected]
donThomaso
New Member
are there any cheaper than the mini-extractor-45g from bestvaluevacs? (cant post links) and can i use it with a 3 cfm pump? is 350ml butane for 45g weed enough?
Last edited:
Fadedawg
Well-Known Member
ASSuming a three volume flood I would SWAG (scientific wild ass guess) about: (45gm/4.1 gm) X 3 X 80% X (.0361/lb/in3 X .601sg) X 454gm = 259 grams LPG
I infer 3 cfm refers to the vacuum pump used to evacuate the system before running.
If you recover actively, you will also need a recovery pump. I typically run the tank bath at 70F with an 85F max and cease at zero gauge before pulling a vacuum to avoid the pentane with a boiling point around 100F.
Fractionally distilling passively will require some very low temperatures on the recovery vessel, if you are to keep the hot tank under 85F.
yimbeans
Well-Known Member
any more info on what these filters are called? greatly appreciated! also have you tried these?
Fadedawg
Well-Known Member
They were custom made HC polishing filters for our experiments and our contact at Vici Metronics was [email protected]. Tell him what you want to remove.