Drip irrigation with coco questions

Billy the Mountain

Well-Known Member
I use square pots if that makes a difference
You'll have to check the available sizes. I used 4" or 6" square ones w/ rockwool. I don't know how big they go.
The round ones came later in larger sizes.
The square ones don't use the drip ring.
They also sell a "universal" one that's kind of a hybrid between the two designs.
 
  • Like
Reactions: TCH

TCH

Well-Known Member
What about using 1/4 soaker hose with a tee for a drip ring?
If you are running straight water, that could work, but im running nutes in the water for coco, so I feel that may get clogged up. I went ahead and ordered the 6" FloraCaps and clips for the hose. That way I can run open ended hose and hopefully not have to worry about clogs at all.
 

nxsov180db

Well-Known Member
If you are running straight water, that could work, but im running nutes in the water for coco, so I feel that may get clogged up. I went ahead and ordered the 6" FloraCaps and clips for the hose. That way I can run open ended hose and hopefully not have to worry about clogs at all.
Yeah I am running nutrients too, I thought about the potential of clogging as well, especially once they aren't in use, in-between harvests. Maybe If I just use water for the last couple days it'll flush them out..
 

gr865

Well-Known Member
I currently run coco in 1-1.5 gallon hard pots with blumats. They are in 12" saucers that all sit in a tray in case of a runaway carrot. Well, after this last week of dealing with some bad lockout (all my fault. Who knew you were supposed to flush the pots with blumats every so often? Lol) and having to flush the pots with gallons and gallons of feed to bring the EC back down to acceptable levels and then having to suck it all out with a little 1 gallon shop vac, I am over that life.

1. Opinions on a purpose built tray for drainage that my pots sit directly in, but its sloped for drainage. Either plumb it into an old drain or shop vac it from one location in the front of the tent instead of 6 individual saucers and having to lean under the netting. Or do I go with 6 saucers/stands that have built in drains that can be plumbed together with pvc pipe, like the floraflex system.

2. I'm looking to add a drip system so I don't have to worry about flushing under normal circumstances and can just feed to runoff as many times per day as I'd like. And, if I do need to flush, I can do so via the reservoir and let it run straight to a drain or a condensate pump. I know I have an older aquarium pump laying around. I'll need to check the gph and lift on it to see if it's enough. If not, there seem to be plenty of $15-30 options. What are the octa-bubblers I see? Just a manifold to split water lines? Or do they even the pressure out?

It appears that to set up the drip system, I'll need:
Pump
Timer
Supply line, large and small
Octa-bubbler(s)
Drip rings of some sort

Other than determining saucers or tray, is that it as far as the drip system goes?

I will be running 4-9 plants in a 4x4 tent depending on setup I decide on. I can see that fluctuating in the future depending on strains and timing, etc.. probably 4-6 would be the norm. As far as nutes go, I'm open to suggestions, but do like the one or two part stuff. Dry is preferred because it tends to be considerably cheaper. I had decent luck with MaxiGrow and MaxiBloom but have heard they can clog up in drip systems.

Thanks in advance!!!
Just a point I want to make here, going Cheap will lead to headaches. Cheap pumps tends to break often, be sure and look for a timer with seconds on it.
Here is the setup I use for both Coco/Perlite and modified Ebb and Flow.
12 volt RV Pump and filter
20221005_105552 2.jpg
55 gallon rez, only using 30 gallon at a time.
20230123_082320.jpg
Orbit 8 port manifold am using 6 ports in my current grow.
20181005_095126 (3).jpg
Rainbird stream emitters
20181005_095114_LI (2).jpg

This was a previous grow, I am using Coco/Perlite again but this setup works for most forms of Hydro.
 

Sk-one

Well-Known Member
If you have a 3D printer or access to one, you can make your own drip rings that have great coverage for pennies
IMG_20211123_102347_778.jpg
 
Top