ebb an d grow plans

I am planning out a new setup. i will consist of the follows:
1x ebb n grow 12pot system
1x 1000w hps/mh electronic ballast
1x air coolable hood
1x light mover rail
1x 6x8x7h grow tent
2x misc fans to circulate air and co2 in room
1x huge carbon scrubber
1x 3 part GH nutes (4-2-1)(1-2-4)
Co2 setup with fuzzy logic monitor system
any comments or suggestions would be greatly appreciated.
-should i go with Co2 tank or try that new Co2 booster bucket thing?
-how many cfm fan should i use to cool that light in order to have it as close as possible to my plants?
-bloombastic?
-expected yield and turnaround?

Useing a co2 tank and reguator gets you much much more control on co2 with a goal of maximixing yeald id go with that...

That setup sounds pretty spiffy, what did you spend? If you dont mind me asking. (or are you gona spend.)

the ebb &gro is a great and easy set up to have. Just remember the plants will at least double in flower so dont get to carried away (i did, its a little crouded)co2will help with the high temps. Also assuming your getting a vented hood? get about 250-300 cfm for your light i run mine 15 min every hour it exhaust as it cools the light. goodluck

how often should the pump run and how long?

yield on see more buds vid with those buckets was 4lbs off 2kwatts i believe.
I have a waterfarm im trying and the buckets look a bit better.
Just check out how its built and add on diy style buckets.
I saw a thread where somone had 3 and four clones ine each bucket...trees!