Build a bubble cloner. Pick a container to fit your needs. I have a small square screw bucket with 5 spots on the lid and holds about a gallon of water. I also have about a 16” x 32” tote that’s about 8” tall, and holds 24 clones.
2” net cups with bottoms cut out
Neoprene clone collars.
Enough air stones to get the water rolling. Oxygen is your friend.
Big enough air pump for container. My small container uses one 6” stone, and my large container uses 2 or 3.
Aquarium heater to keep temps around 70
Cut your clones. I like bigger clones with at least 3 nodes. Use razor to cut bottom on a 45. Lightly scrape sides on last inch of stem and place inside clone collar then into net pot then into cloner. Cloner should be filled with water up to bottom of net cups and light bloom nutes added (the high P and K is needed for rooting not just flowering).
This is set it and forget it, roots in 7-14 days
These cooked a little too long but I was sexing these cuts since I’m running regs this cycle. You’ll want to transplant them a lot sooner
View attachment 4324126