• Here is a link to the full explanation: https://rollitup.org/t/welcome-back-did-you-try-turning-it-off-and-on-again.1104810/

First Time Grower (with pics)

C

chicago6900

Well-Known Member
Here is my plant. I don't have any idea what strain it is. I just planted some seeds and this baby popped up. What do you guys think? Male or female? If it is female, is it time for the flowering stage? I have no idea what I'm doing, I been reading the forums for help. Any comments or suggestions would be greatly appreciated. :leaf:











 

Attachments

C

chicago6900

Well-Known Member
also there are 5-6 small branches on the bottom that are roughly 12inches long, is it possible to cut these and make clones or is it too late?
 
RASCALONE

RASCALONE

Well-Known Member
not a very good idea to clone from plant in flower,can take much longer to root if at all.u say its only been 12/12 for a few days?u might still b otay,just not recomended.....rascalone
 
C

chicago6900

Well-Known Member
also, this is day 3 of 12/12. i noticed that some of the leaves are starting to curl downwards. they didn't start doing this until i put them on 12/12 is this normal? the weather out here has been in the upper 70's lower 80's and 60's at night. my plant is in the garage so its prolly 5-10 degrees warmer at night, is this ok?
 
C

chicago6900

Well-Known Member
I got a couple more questions. I was checking on the plant today and saw the roots coming to the surface on the sides. I was using a 1gallon pot. So I decided to transplant it into a bigger 2 1/2 gallon pot. Good idea or no? Also when I was moving the plant, I slipped and broke off one of the lower branches.
How bad is this going to effect me? Any chance of saving the broken branch for a clone?
 
UnEmploymentDude

UnEmploymentDude

Well-Known Member
If that branch is still alive then go for it.

The curling might have happened because of a little bit of over watering, under watering or heat stress. But as long as it doesnt fall over and die, your ok.
 
C

chicago6900

Well-Known Member
UnEmploymentDude said:
If that branch is still alive then go for it.

The curling might have happened because of a little bit of over watering, under watering or heat stress. But as long as it doesnt fall over and die, your ok.
Click to expand...
Thanks for the reply. I haven't watered in a couple days, but when I dug her up today and replanted her, the soil way down was very wet. I made sure I put some hole in the bottom this time for it to drain. I really don't think heat is a problem, I think it might be getting too cold outside for her. It's in the 40's at night and 70's in the day now. She is kept in the garage so there is prolly a 5-10 degree difference. Any advice on what I should do? Move here inside the house? Put a heater in the garage? Any help?
 
NJsmok-a-lot

NJsmok-a-lot

Well-Known Member
Hmm thought I saw a nut in one of the pics(indicating a male) but theres also hairs so possibly a hermie. Can you get clearer pics?
 
C

chicago6900

Well-Known Member
I will try to get some clear pics tomorrow. I have them flowering right now, so I can't take any pics as they need complete darkness. My plants seem to be wilting a bit. They are still green and look strong, but the leaves are starting to curl downwards. I haven't watered her in a couple days, any idea what it could be? I just transplanted her in a big 2 1/2 gallon pot today because I saw some roots coming to the surface. Hopefully this will help!
 
Gryphonn

Gryphonn

Well-Known Member
Did you give it a good soak when you transplanted? Also, try some Fish emulsion fertilizer. This is a bit of late advice, but when transplanting use a weak mix of fish emulsion fert to avoid transplant shock. You'll probably find that the wilting is transplant shock and may or may not affect the overall robustness of the plant. Don't over water it either, else you'll end up killing it with kindness.
I'd strongly suggest getting it into somewhere where the temperatures aren't quite so extreme between minimums and maximums as well.

Cheers
 
You must log in or register to reply here.
Top