GH G-M-B/N-P-K ratio help

rollint

Member
Setup:
8x8 indoor totally enclosed with panda plastic temp maintainedat 75-79 degrees
1000 watt magnum XXXL reflector
MH for Vegetation high PAR ratings, HPS for flower bothdimmer friendly
Electronic dimmer 50/ 75/ 100% canget plants right up to glass
Exhaust: pulled through carbon filter then enclosed lightand pushed to outside ambient
Method: Flood & Drain
Reservoir: 30 gallon, temp maintained @ 68-70 degrees
Net pots: 8”wide 6”deep
Medium: Hydroton
2) 2x4 trays holds 20 pots but lost three at seedling stage so, 17plants total
Strains: Delicious seeds cotton candy, Dutch PassionBlueberry, all feminized currently between 14-18” tall
Yielding methods: LSTing, topping, FIMing, clearing outbottom 1/3 to get to sweet spot
Nutrients I have: GH G-M-B
Using a version of Lucas 0-8-16 because I have added a smallamount of cal/mag
Meter: ppm/EC/pH all in one at a .7 conversion
Put back method: what they need sometimes full watersometimes reduced nutrients to maintain or increase nute levels.

Current nutrient stats at end of 6week vegetation going intoflowering: 0-5-10/0-150ml-300ml/G-M-B plus some cal/mag = ppm970/EC 1.37/ph5.7

I want to get to a 1-1-2 early flower and then 0-1-2 N-P-Kratios
Question: how can I do this with the 3 part G-M-B series?
Where I believe my confusion liesis this: since I ‘am running currently only micro5-0-1 and bloom0-5-4 at 1:2(5-10) is that still a 5-5-5 or is it a 5-10-12 since the bloom is doubled?

PS plants have had no deficienciesso far really just a small amount of yellowing but just added only water to putback and went away each time.
 

rollint

Member
Can I just run micro ( hard water)5-0-1 plus bloom0-5-4 x3= 0-15-12 to get to a 5-15-12, this gives me a (1-3-2.4) near my goal of 1-3-2? if my figureing is correct? these nutreints ratios regardles of manufacturer is still not clear to me....
 
Top