HEY LADIES! check out my GINORMOUS

BOBBY_G

BOBBY_G

Well-Known Member
heat sink!

upload_2016-2-28_4-59-52.png

30x 30 x 1.5" aluminum waterblock (formerly some university research surplus gear) bought on ebay with through holes exactly at 2" on center (see cob holders are a perfect fit)

what would you do with the ability to ice-cold chill 91 cobs?
 
BOBBY_G

BOBBY_G

Well-Known Member
BuddyColas said:
So what's the other side look like?
Click to expand...
that was the side they used to mount, its got raised 1" round pads around the holes and the cobs would not sit flat. this flat side is the 'back' i suppose (which kinda sucks as then the water ports are on the bottom and ill need to attach a vent to the top of the block to vent air
 
BOBBY_G

BOBBY_G

Well-Known Member
i dont think its baffled. may be able to tell with a heat load and ir thermometer

its welded so cant be opened.

you can see the 2x fittings in the opposite corners int he first pic
 
G

grouch

Well-Known Member
BOBBY_G said:
i dont think its baffled. may be able to tell with a heat load and ir thermometer

its welded so cant be opened.

you can see the 2x fittings in the opposite corners int he first pic
Click to expand...
It would be good knowledge to know for spacing and cob placement. Know anyone with FLIR equipment?
 
BOBBY_G

BOBBY_G

Well-Known Member
i think the $20 ir thermometer from harbor freight would do the same thing if used appropriately, youd just have to take a bunch of measurements
 
You must log in or register to reply here.
Top