MarsHydrofactory
Well-Known Member
Dear RIU Fams
Our newest inline fan and carbon filter combo kits already release for some time and receive a good response. below is the article about the them. hope it is good for you guys to use them and receive a good harvest
by the way,if you are interested to buy them, welcome to use the code: ROLLITUP to get the extra discount on www.mars-hydro.com hope it is good for you to save moreAir circulation is important for indoor growing. Indoor cannabis plants are usually grown in a relatively sealed environment, such as a closet, tent, or room dedicated to growing. A fresh air supply helps cannabis grow quickly and protects the plants from certain pests and molds.
Mars Hydro Inline Duct Fan can provide fresh air to your sealed growing environment. They offer four and six inch fans with different controllers. You can choose the right fan according to your growing area and needs. This article serves as a tutorial to demonstrate how to install and use Mars Hydro inline duct fan kit inside a tent.
All items in the kit
Clamps, Screws, Belts, Probe Sensor, Thermostat Controller, Carbon Filter, Fan, Duct
Installation Procedures
Step 1: Hang the fan and filter
Hanging the filter and fan to the same height, then connect them. When connecting you can also cut down part of the duct to connect the filter and the fan, which will be more sturdy.
If you do not know how to tie the belts, please refer to the tutorial below. This method of tying the belts makes it easy for you to adjust the height.
Step 2: Connecting the fan to the duct
Connect the fan to the duct and secure them with the clamp. Be careful when using the clamp, it is sharp.
Step 3: Connects the fan to the controller
Connect the sensor and fan to the controller, remove the cap before you use the probe. Then power on and you can use it.
The fan and carbon filter can be moved into position to suit your needs. For example, On the inside, top or side of the tent.
Thermostat Controller Tutorial
Button diagram:
The controller has four modes, The following steps teach you how to operate the controller.
ON MODE:
The fan keeps working at set speed
Fan speed can be adjusted from 1 to 10
OFF MODE:
Fan won't work
Press UP/DOWN buttons to adjust display brightness
Press UP/DOWN buttons at the same time for 3s to convert Fahrenheit to Celsius
Press the MODE button and LEAF button to rectify the probe temperature and humidity
TIMER MODE:
Set the fan's working time, with a countdown
Fan works at the speed you set in ON MODE
AUTO MODE:
4 Triggers can be set: High/Low Temperature, High/Low Humidity
When the probe temp/humidity exceeds the set ones, the fan will automatically work till the probe temp/humidity is the same as set ones.
