Is it ok to completely stop feeding?

snoeman032

snoeman032

Well-Known Member
Dr. Who said:
All strains require different feed levels.
Some are so close you never will notice.

What your finding, is that these need a little less. I suggest you cut the nutrient your adding to water for a feed solution, down by 25% and try that..
See how they react and adjust again if needed...

This is called dialing in. You dial in your feed to the strain....You should have a notebook and be recording these things.....Once you find your dial in for this strain. It will be in that notebook forever.
Easy to refer back to in the future.

Good luck......BTW. They don't look that bad. The N looks a bit high in some pictures.....Hence the overall lowering of nutrient in the mix..
Click to expand...
Thanks man you’ve been lots of help. I’m gonna go with what you said and get “dialed” in thanks again
 
Dr. Who

Dr. Who

Well-Known Member
snoeman032 said:
Thanks man you’ve been lots of help. I’m gonna go with what you said and get “dialed” in thanks again
Click to expand...

Simple point of Dial in work to always remember.

"It is far easier to start low and adjust up, then to have to adjust down from nute burnt/overfeed plants."

Reducing high N in most cases. Is only effective to new growth....Once shiny, your pretty stuck with it.

Yours were not too bad... across the board.
 
K

Kattsjungle

Member
snoeman032 said:
Thanks man you’ve been lots of help. I’m gonna go with what you said and get “dialed” in thanks again
Click to expand...
How are your PPM’s so high? What kind of water are you using? My well water comes out at 800ppm, so I have to use RO water which is better because I know exactly what’s going into the plant.
 
You must log in or register to reply here.
Top