hebrewdiver
Well-Known Member
When making oil should you use fresh picked buds and sugar leaves before curing and then decarb? Or should you cure then decarb before placing in oil?
Making canna-oil
- Thread starter hebrewdiver
- Start date
OldMedUser
Well-Known Member
You could put them fresh cut into your oil of choice then do the decarb right in the oil, strain and enjoy.
Read my thread on how I've done it in the past down in my sig.
Read my thread on how I've done it in the past down in my sig.
Fadedawg
Well-Known Member
We usually pull the fan leaves and hang our plants until the small stems snap before extracting the buds and sugar leaves together, but we have also frozen fresh material and extracted it that way. Both produce good oil.
We only decarb if we are going to eat the oil or use it in suppositories, but when we do, we decarb the oil, not the plant material.
We only decarb if we are going to eat the oil or use it in suppositories, but when we do, we decarb the oil, not the plant material.
HenryTheEighth
Well-Known Member
Best way to make oil is to use hash.
Fresh frozen buds and make ice hash.
Decarb hash in oil for hash oil.
Decarb hash in oven in Pyrex with foil lid with just enough coconut oil to make a gelato like slurry.
Add Isopropyl alcohol 100% to the oil after decarb process to dissolve and thin it then you can filter the hash oil through a 25 or 45 micron filter. Then evaporate off the alcohol for clean oil.
Put clean oil in dropper bottles.
But if you don’t want do the alcohol process just freeze your hash oil to keep it like gelato.
Squatchsmoke
Member
...then you can melt it down whenever you need oil? This is what I'm looking to do because I was looking for a way to make my own oil for making Thai stick cigars.
cannabiscrusader
Well-Known Member
We're just going to ignore the suppositories? Canna oil right in nature's pocket huh. I'll try anything twice