WTF do you charge for all the work??
i have heard of folks taking whole runs and with the TANE still a little frothing rolling the nugs then pulling them with a strainer dry a little then roll in keif . THEN into the vac oven with no heat just vac...
it was a pro looking coating job for sure . looked GLAZED...
WTF do you charge for all the work??
i have heard of folks taking whole runs and with the TANE still a little frothing rolling the nugs then pulling them with a strainer dry a little then roll in keif . THEN into the vac oven with no heat just vac...
it was a pro looking coating job for sure . looked GLAZED...
yea buddy you do that an report back PLEASE i gotta know for sure if its below the 250ppm hydorcarbon level...
kids that do this are PROS but care little for the custies so not sure if the tech is on point...
i'm going to the clinic tomorrow to handpick some buds to try the melt in a spoon then roll it method. i'm going to roll it in the heated BHO, then let it soak in and dry on some parchment paper, or maybe on my silicon baking dish, then when it's dry roll it in heated BHO again to get it to soak in as much area as i can.