licoricetree
Well-Known Member
Mine have a cal deficiency
Erm Epsom is Magnesium sulfate not calciumCosulfate not calcium post: 13403258 said:no im talking the usual formula people use (3-2-1, though im using a differenet ratio
the 5-12-26 has 5% Mg
the calcium nitrate has plenty of calcium
i dont use epsom salts
i also think that bleaching is commonly mistaken for deficiency and may be what some people see esp under blurples
And why did u come off as a smart ass using words likein my opinion its a myth
more than likely people not adapting to the higher usable ppfd and its just common to get deficiencies. Calmag is a great product but now that im using jacks i have 100 ppm ca and 80 ppm mg from the nutes alone, no epsom salts or supplemental calcium for me
i think he means he supplements with calcium nitrate to the Jacks hydro formula cause it is lacking and doesn't use Epsom.Erm Epsom is Magnesium sulfate not calcium
Anybody that believes an LED light causes a calcium deficiency needs to just stop growing immediately. Go to your local witch doctor and pay them to do it. You'll have as much success.I have been using the search engine to find information on cal/mag deficiencies that may be cause related to using led lights.
False, I've grown the same strains, clones and when I'd my 600w n 400w mh I never got Calmag issues in veg ever, it only occured when I flipped...do u know why?Anybody that believes an LED light causes a calcium deficiency needs to just stop growing immediately. Go to your local witch doctor and pay them to do it. You'll have as much success.
The fact is, any calcium deficiency you were going to have started long before you ever changed the lights. It takes time for a plant to suck up all of it. You just happened to change the light towards the end of what was already a problem going on several weeks previous to that.
That's exactly what it is mate the cobs produce less heat so cal n mag ions can be less mobile. I'd suggest foliar Calmag for a quick hit either when lights out when stomatitis are open to release oxygen or just before lights on.i prefer just as lights out as the plant has time to absorbed .if u need a wetting agent use natural soap no fragrance or any of that crap but tbh I just foliar the underside n once on top near daily...not lashings now but they just been flipped so I m I may up the dose,the plant will tell me... Heck here's a pick I've not deleted yet think it was just before flip. now I veggie em under 2 cob 4 at half power 100w and my cobx9 also half but now since I flipped they seem slick n I found if ur girls are getting cold find some sort of Styrofoam to sit em on.thinking about this today as were just getting into spring and the young cuts arent doing what they should. they are on the bottom of a tent in the basement and im sure are not at right temp. last time getting them up off the floor and putting the tent on a t-stat controlled fan and they were off and running. i wonder if a lot of the problems people see when switching to LED arent in part as a result of leaf temp issues
I've me sms twin fan speed controller kept at 26 but she barely passes 25c with all lights on but at the start that many cobs produced a fair bit of heat so where I'd usually attach my ducting to the hood like I did with my HPS,I pulled in the ducting secured it away from the cob fans to the middle of the tent n attached a ram 9" off the frame so my shit don't ever heat(grow rooms towards where the sun rises)My switch from hps to cobs has been a learning curve as well.. I believe temps, as was stated earlier, is a big issue.. I bumped my temp up 3-4 degrees C and seen a big improvement..
Ppfd is photosynthetic photon flux density. It's used to see how much par is present at any given point ur aiming for 400nm_700nm and of course it's a good idea to add Calmag n not just cal as they usually Def around the same time,think it's due to the ph range of absorption but try some endomycorrhizal next time it's pricy but insane I'm adding to my compost since I recycle soilI have always grown with HPS and after switching over to COBs (same PPFD as before) I have consistently needed to add extra calcium.
Calcium is taken up passively with the water flowing into the plant. Plants under led light evaporate less and therefore they have more problems taking up calcium. So you can try to increase the evaporation or increase the calcium ratio a little.
Never had magnesium issues, but it's always safer to add magnesium as well when you add calcium.
Lolz@wietefras it's because LEDs aren't putting out the spectrum your plant needs so it develops a deficiency, no LED is full spectrum, they are either a blue diode sprayed with a phosphor coating or a bunch of colored diodes that are combined to imitate white light, none of them actually produce a true full spectrum light ,they are all targeted spectrum even the white light LEDs.
If you used blurple leds the problem would be even worse. Blurple LEDs can't even grow lettuce good, the color is terrible for the plants and makes them look ugly and tip burn.
Plant's developed over billions of years to grow with the sun's spectrum, which is a ball of burning gas. There is no burning gas in an LED diode.
It's why if you go from a 250w hps to a 1000w hps you wouldn't have the same issue you are having. This problem has nothing to do with light intensity or par or anything it has to do with the crap spectrum LEDs produce. It's the main reason i no longer use my LEDs as a main grow light, they are best used as a supplemental light.
Er, besides shooting your mouth off making assumptions maaaybe you should stop growing because with an attitude like that there is obviously nothing to learn from you. I am simply doing research and don't recall putting out the welcome mat for trolls.Anybody that believes an LED light causes a calcium deficiency needs to just stop growing immediately. Go to your local witch doctor and pay them to do it. You'll have as much success.
The fact is, any calcium deficiency you were going to have started long before you ever changed the lights. It takes time for a plant to suck up all of it. You just happened to change the light towards the end of what was already a problem going on several weeks previous to that.