PC case/ micro build

matthebrute

matthebrute

Well-Known Member
how do you have them wired? that could make a difference.


from my experience, not with a micro PC build but a small DIY cab. i had heat issue, turned my 1 inch passive intake holes (had 2 one on each side) into 2 inch passive intake holes and it fixed the problem, the other fan also may not be blowing alot of air because of all the negative pressure it doesnt have any air to blow?
 
B

Bleezyboy1990

Active Member
Yeah my intake is on the bottow but its about 4in across and aprox. 8-10in long and just a drilled out mesh with a plastic mesh guard and its sitting on two books with a space by the intake. I don't think much blockage is there but idk how else to go about it without re doing at least one whole side? This is my intake
 

Attachments

matthebrute

matthebrute

Well-Known Member
just put it in the fridge :) lol jk. i really dont know man. i dont think a intake fan is going to help you as much as you would think. if you have both fans rigged to the same adapter maybe try and find another adapter and run them on thier own plug, this might give you more air exchange.
 
B

Bleezyboy1990

Active Member
Yeah I don't get it tho. The adapter says two 12v leads. I think it really is just the fan because I have another one that was blowing harder on the same adapter so ill just swap fans and use it as an exhaust still and passive intake. I'm also going to do another intake on the back so hopefully it'll all come together!
 
B

Bleezyboy1990

Active Member
Okay cool. Couple more things to do and this bad boy is ready for the customer! Lol already found my next build too! Dresser for $25 at goodwil! :)
 
matthebrute

matthebrute

Well-Known Member
looks great man.

check out my new thread i have a dresser for a cab and some pics up, its not stealth but whatevs :)
 
You must log in or register to reply here.
Top