Thanks I didn't think about this, I probably should just stop using RO all together with my well water being about 6.8 ph and 120 - 150 PPM no filters or anything. I just started with the RO and have been afraid to change. After RO my ppm is 0 -1 PH is still 6.8 range.if you use RO water, mix it half with tap water. it will give you a ph buffer and will hold its ph for longer. let the tap sit out for 24 hours plus if you are using microbes. if you arent using cal mag you should get some in there as well. Other than a resi change, try to not raise your ph more than .5 in 24 hours. if you add back pure RO water, give it a 100 ppm of cal/mg, or half/half tap to RO. otherwise you might see a significant ph drift.
My tap water ph is 7.1 and has around 68ppm. Ty for the advice.the buffer solution I got will keep the peen in check lol and I didn't go with a cheap Penn this time o yea stay away from the yellow ph600 penns lol. Guess you get what u pay for. Anyways dangledo I checked on the girls around 5 befor the lights went out and they seem to be stable not any worse so keeping fingers x till morning. I have noticed the swing with the add backs it's funny you say about the cal/mg I have a post out asking of it and I sorta was left thinking I didn't need it, I may have just took them wrong my bad. I do have a young one in a solo cup was going to give her a bucket of her own but I may just hold off to see how this pans out, soil may be the only way for my lol. I do like the idea of playing with the big guns but maybe I'm just not smart enough for dwc I will be getting some cal/mg 2mor and if there is any other tricks I may need to no just hook me up. Any advise I take in sort out and use what's good so bring in the good stuff. Thanks again.
unfilterd well water shouldnt be used in dwc. it may contain organisims from algea to water molds. (root rot, slime, diatoms) that are especially bad in dwc. even tap water used should be of good quality(filtered at the water plant). good info on thread page above.Thanks I didn't think about this, I probably should just stop using RO all together with my well water being about 6.8 ph and 120 - 150 PPM no filters or anything. I just started with the RO and have been afraid to change. After RO my ppm is 0 -1 PH is still 6.8 range.
Thoughts?