Plants problem . Hydroponics with AN !

ProGrower707

ProGrower707

Member
Anyone can help .
27 gallon res. with 4x4 table tray
room temp 74 water temp 72

i use blue lab combo meter .
it now first week flowers .
200 ml A & B SENSI BLOOM
100 ml Kushie kush
100 ml rhino skin
100 ml senis zyem
100 ml bud factor
100 ml bud intatior
100 ml bud candy
30 ml root elxaltuor
12 ml Orca ( liquid)
ph 5.6
ppm 750
i addes 60 ml cal mag bloom
ppm 850
can anyone help ? thanks
 
ATL HYDRO

ATL HYDRO

Active Member
The first week of flower you are supposed to go easy on nutes..... But your ppm looks plenty low enough... So i don't know... Did you have any burn problems before switching to flower? And what were your ppms during beg?
 
ProGrower707

ProGrower707

Member
No burn during veg stage . i added cal mag 100 ppm . i not sure if cal mag will lock out nutes. cuz AN said if using AN don't need add cal mag . i not sure . ...
 
xzackly

xzackly

Member
Cut out the cal mag. If you're using Bud Candy that already has magnesium in it, so you are overlapping nutrients which can cause nutrient lock. Reduce the PPM slightly on your base nutrients for two or three days as well, if to be conservative.
 
MrGhettoGrower

MrGhettoGrower

Well-Known Member
How big are the plants? 1st week of flowering 850 ppm's is on the high side unless you your plants are bigger than what I flower at. How often to you flood the table or however you water it looks like a little to much possible over watering causing that drooping? I use sensi bloom too in my hillbilly hydro, Their all rock wool using none of the AN additives ~ These are 2 days in flowering

Picture 399.jpg
 
ProGrower707

ProGrower707

Member
Thx for reply. I set my timer water up every 6 hours. 4 time a day . water sit for about 5 min in tray. today i dumped water out and ADD RO WATER added A&B @ 350 ppm . and i added 50 ml of bud candy , bud intaior , bud factor , rhino skin . senisyme . and in 27 gallons res. ppm is still 350 . i will start off slowly and will see in next day or two .
what you think ? thanks
MrGhettoGrower said:
How big are the plants? 1st week of flowering 850 ppm's is on the high side unless you your plants are bigger than what I flower at. How often to you flood the table or however you water it looks like a little to much possible over watering causing that drooping? I use sensi bloom too in my hillbilly hydro, Their all rock wool using none of the AN additives ~ These are 2 days in flowering

View attachment 1775047
Click to expand...
 
PetFlora

PetFlora

Well-Known Member
Is this an E&F rig? If so 27g seems like ~ 50% more than you need, not that it would hurt anything, but you are using ~ twice the nutes ($$$$$). Measure the volume of the table and double it for rez gallons.

Contact AN and ask what order to add these nutes. Improper order can lock them out. Also 100ml of each/all those seems bit unlikely. but again, check with AN. hth
 
ProGrower707

ProGrower707

Member
PetFlora said:
Is this an E&F rig? If so 27g seems like ~ 50% more than you need, not that it would hurt anything, but you are using ~ twice the nutes ($$$$$). Measure the volume of the table and double it for rez gallons.

Contact AN and ask what order to add these nutes. Improper order can lock them out. Also 100ml of each/all those seems bit unlikely. but again, check with AN. hth
Click to expand...
I use half what AN bottle said . it said 4 ml per l water . that pretty high . so i do half . 200 ml per l ..... :idea::joint:
 
dirtysnowball

dirtysnowball

Well-Known Member
what is the npk of AN

im pretty sure its under 10-10-10, use full strength. or enough to get your total npk around ~10-10-10
 
ProGrower707

ProGrower707

Member


plants doing really good i lower my ppm and ph 5.6 to 6.0 . flood 4 time day time none at night / got any idea why it start from bottom on way up ? ppm 700 .. thanks
 
You must log in or register to reply here.
Top