Vents are 8".. I pull air from outside the house in a window box, and it exists out another window box. I live in the high country, temps are never over 75 outside. I use a 8" Can fan, this fan is only for the lights, its only on when lights are on... I do understand the lights need to be resealed. I use aluminum duct tape to seal it, this prevents co2 leakage. I have a 8" intake pulling from outside in, everything is on a CAP atmosphere controller (intake and exhaust). Also a 8" exhaust fan attached to a can carbon filter. Also running co2, also works off CAP controller connected to the cap ppm-1 meter. I have the co2 line attached to a CAP osocialting fan that pushes a lot of air. I run recirculating hydro setup. I do not have chillers, I really don't need them. Thing is I think you think the temp of the light is burning the buds, it is not. The glass on the lights are as cool as the concrete floor, I think the light is too intense therefore burning them, like a sunburn. And it sucks because its all the really nice tops end up looking fucked up. So this run I'm 12" away. Any closer and they get bleached, from exp... Any suggestions? Thanks.
Basically this is the configuration..