Ro water conditioner

1212ham said:

That sounds a little high for RO, I see about 8-15 from store bought RO. I don't understand why you'd have problems with RO at 20-30ppm, but it's recommended to use a water softener before the RO filter.

"If your water sample shows that you have hardness, iron and sodium in your water, a softener needs to go in front of the RO system to remove the Calcium and Iron from the water. Otherwise the Calcium and Iron will quickly exhaust the RO Membrane."

Reverse Osmosis Vs. Water Softening: Do I Need Both?

If you have a water softener in your home, you may feel pretty good about your water. But in fact, even after being processed by a water softener, impurities may remain in the water you drink and w…

blog.watertech.com

Click to expand...

bwheat said:

More like a slimy foam. It is slick buy very airated.

Click to expand...

Rdubz said:

Wait I don’t have city water and your running softener before ? I think u should never use anything from a softnev


I had the same thing from a bucket I was using with just RO water in it I had it in my room to give more RH and from the light being right on it that’s what happened it was thick kinda but ya I know what u mean

Click to expand...

Rdubz said:

Wait I don’t have city water and your running softener before ? I think u should never use anything from a softnev

Click to expand...

bwheat said:

I switched back to ro water and also tried mixing in the cal mag and letting it sit over night and am getting much better results. I was mixing in the reservoir but i don't think it was mixing it properly. The reservoir is back to clean after getting the tap water out of there as well.

Click to expand...

Iceman8700 said:

Hey..I'm kinda having the same issue..
Could you pls explain how you go about the process in detail while making a new reservoir by adding calmag 1st.
Thanks..

Click to expand...

bwheat said:

The solution for me was to run double the reccomended dose of calmag, and the thing that seemed to fix the problem was mixing the calmag in to the water well and letting it sit for 30ish minutes before adding the micro. I use gh calimagic calmag so there isn't a lot of nitrogen like some others and using extra didn't have any negative effects. The mixing process seemed to be the fix though. I now let it sit for a bit after mixing each thing in and was able to get very dialed in on my coco grow.

Click to expand...

Iceman8700 said:

Thanks for the quick reply..
I'm doing dwc with maxibloom and calimagic. I never tried increasing the dose above 1ml/l.
So ur saying doubling the dose and letting it sit for 30 mins as compared to overnight is good enough?

Click to expand...

Iceman8700 said:

Thanks for the quick reply..
I'm doing dwc with maxibloom and calimagic. I never tried increasing the dose above 1ml/l.
So ur saying doubling the dose and letting it sit for 30 mins as compared to overnight is good enough?

Click to expand...

Iceman8700 said:

Doubling the dose would raise my ro water ppm from 22 to 600..I won't be able to mix in maxibloom then I guess..

Click to expand...

bwheat said:

Yeah, i did it on my drip hydro setup, and also with my coco grow and the waiting 30 min an double dose made them about the healthiest plants i have grown. I had calcium problems with the ro water and 3 different nutrient lines, and 3 different mediums, had just used tap water and ocean forest before so had no problems, but the ro in every situiation needed the extra calmag. I switched to doing a 2n'd ph test after the meter with liquid drops as well to verify and for me it has made a world of difference.

Click to expand...