spindly bitch info

wee9bar

Member
how would 1 (as in me) stop a plant from going to spindly as in shortin the gaps between side shoots :confused::confused::confused::confused::confused::confused::confused: any info is info so dont hold back my good friends


wee9bar-365813-albums-2nd-grow-indoor-stealth-picture1783024-imag0092.jpg
 

bryon209

Active Member
lower your light if its to much then upp the wattage and pull it back....the stretching is what you are referring to right?
 

ShadyStoner

New Member
Looks like you have three plants in the pot - be careful they will probably die as they grow older.

When you flip to 12/12 the plant will still grow 2-3 times bigger than it is now, I would suggest topping it and lowering the lights to within 1-3 inches of the top
 

SlimJim503

Well-Known Member
HTG supply dot com has 24 inch strip T5 lights get two for the back corners run top to bottom for side light think the pair is like $50 and they run off one power cord you can link up a bunch of then not sure how many but you only need two and from what i hear the plant can touch then just have a flow blowing over the bulb. They also have a 150w DIY hps kit or light kit with remote ballast or even one witht he ballast built in but i would go remote so you could get the heat of the ballast out of the box then you just blow air on the bulb and it stays pretty cool but you need more light or to rethink your box. You could lay the box on its side prop the plant up to support it while leaving it just how it was and tie the top down by taping string a crossed the door and put your light/lights above the plant so it shines straight on the side that would be ill as fuck. Then you would end up with "2x times the nodes" in colas just LST the branches and help them all face up out of the box then LST/Spread them apart and flip 12/12;-)
 

wee9bar

Member
i listened 2wat use both said an tried 2 work with wat iv got only iv broken a chest of drawers but its unfinished

IMAG0104.jpgIMAG0105.jpgIMAG0103.jpg



HTG supply dot com has 24 inch strip T5 lights get two for the back corners run top to bottom for side light think the pair is like $50 and they run off one power cord you can link up a bunch of then not sure how many but you only need two and from what i hear the plant can touch then just have a flow blowing over the bulb. They also have a 150w DIY hps kit or light kit with remote ballast or even one witht he ballast built in but i would go remote so you could get the heat of the ballast out of the box then you just blow air on the bulb and it stays pretty cool but you need more light or to rethink your box. You could lay the box on its side prop the plant up to support it while leaving it just how it was and tie the top down by taping string a crossed the door and put your light/lights above the plant so it shines straight on the side that would be ill as fuck. Then you would end up with "2x times the nodes" in colas just LST the branches and help them all face up out of the box then LST/Spread them apart and flip 12/12;-)
Looks like you have three plants in the pot - be careful they will probably die as they grow older.

When you flip to 12/12 the plant will still grow 2-3 times bigger than it is now, I would suggest topping it and lowering the lights to within 1-3 inches of the top
 

f1bud

Active Member
M8 u need to rearly get urself a better bulb setup, a mean if ur goin through the bother to grow them then man u gotta get ya self a better light maybe 400 hps and ur stretching problem would be solved u will still have the heat issue so that wud need dealing wiv but if u want good nugs potent shit by hps asap
 

DR. RESINTHUMB

Active Member
Yep light is the problem here as in not enough...having 3 plants in one is a nebie mistake but i also did that when i started....its all good just remember more light equal more bud sites which equals more nugs
 

wee9bar

Member
M8 u need to rearly get urself a better bulb setup, a mean if ur goin through the bother to grow them then man u gotta get ya self a better light maybe 400 hps and ur stretching problem would be solved u will still have the heat issue so that wud need dealing wiv but if u want good nugs potent shit by hps asap
I have a 250w hps just 2 expensive 2 run well atleast til iv perfected it so if i am going 2 spend money on it i do it right if u get my drift...........
 

SlimJim503

Well-Known Member
you would be better of useing CFL then what your using get the 6500k for veg and the 2700K for flower but what your using is why you have such bad stretch. They make socket Y adapters so you can use more then one CFL per socket also outlet to socket adapters so you can use a simple wall outlet or surge protector thats what i use and zip ties are a micro growers best friend also they tidy up your grow space by getting wires and such up and out of the way. You would be off and running it you put a 150 hps in there like i said just make sure its remote meaning the ballast is not built into the reflector HTG supply sells the one i have and i love it and that truly all you need unless your going to grow trees use 6500k to veg em and the 150 hps to flower also use LST training to keep them short and bushy you need to spend some hours looking over other MICRO growers setups and stay away from the people who have full grow setups meaning if they have over a 400w their info wont suit your space unless your willing to spend hundred even thousands ive also only used CFL from start to finish and the end product was super smoke. 150w for that space and without the right ventilation you'll run into problems now think if you added a 400-1000w its going to be over 100 degrees in there unless you go cooltube and spend some money on the fans ducting etc. You could setup that space for under 300 going with the CFLS and 150w hps or you could spend over 1000 setting up a bigger light and fan setup but i dont think you have the knowledge yet and if i was you i would start small and cheapest i could. Build up to something bigger dont just go full out without the knowledge cuz you will run into problems and end up spending more on a big op then you would if you waited and gained more knowledge about setups tricks and over all how to manipulate the plants. Of course everyone will say go big or go home but it truly isn't the case most of those people are drug dealers not someone just looking to put smoke in their face or medicate themselves only with said crop. I wouldn't go under 23w for the CFL i use 26w cfls myself i like the output and intensity better.
 

*BUDS

Well-Known Member
I have a 250w hps just 2 expensive 2 run well atleast til iv perfected it so if i am going 2 spend money on it i do it right if u get my drift...........
A 250w hps is not expensive to run. You wont perfect it untill you get them under that hps. When you do the nodes will tighten ,stems will thicken and growth will be much faster.
 

MrGhettoGrower

Well-Known Member
Get a 400 watter your be a lot happier than a 250 and it's not much more money to run. I use lumatek you can use either light mh or hps.
This will solve your stretching problem will nicely~
 

wee9bar

Member
i like u already my friend u not ur shit an its as if i new the answer but just 2 stubberen 2 do it im a cheap cunt amn ill admit 2 it (" only cause nobody no's me lol")

im always lukn 4 the cheapest option out even tho in a full time job an have the money but just wont spend it unless i no im makin more back

2 be more honest i dont smoke soapbar/pollen/or grass anymore,, i quit it cuz some1 betted me i cudnt, been of it 6months :( I NO POUR ME,,,,, but dont get me wrong if i grow bud an its got trichromes i well be smoking it, bet r no bet :)

i gave u rep my good friend :-P:-P:clap::clap::clap::-P


you would be better of useing CFL then what your using get the 6500k for veg and the 2700K for flower but what your using is why you have such bad stretch. They make socket Y adapters so you can use more then one CFL per socket also outlet to socket adapters so you can use a simple wall outlet or surge protector thats what i use and zip ties are a micro growers best friend also they tidy up your grow space by getting wires and such up and out of the way. You would be off and running it you put a 150 hps in there like i said just make sure its remote meaning the ballast is not built into the reflector HTG supply sells the one i have and i love it and that truly all you need unless your going to grow trees use 6500k to veg em and the 150 hps to flower also use LST training to keep them short and bushy you need to spend some hours looking over other MICRO growers setups and stay away from the people who have full grow setups meaning if they have over a 400w their info wont suit your space unless your willing to spend hundred even thousands ive also only used CFL from start to finish and the end product was super smoke. 150w for that space and without the right ventilation you'll run into problems now think if you added a 400-1000w its going to be over 100 degrees in there unless you go cooltube and spend some money on the fans ducting etc. You could setup that space for under 300 going with the CFLS and 150w hps or you could spend over 1000 setting up a bigger light and fan setup but i dont think you have the knowledge yet and if i was you i would start small and cheapest i could. Build up to something bigger dont just go full out without the knowledge cuz you will run into problems and end up spending more on a big op then you would if you waited and gained more knowledge about setups tricks and over all how to manipulate the plants. Of course everyone will say go big or go home but it truly isn't the case most of those people are drug dealers not someone just looking to put smoke in their face or medicate themselves only with said crop. I wouldn't go under 23w for the CFL i use 26w cfls myself i like the output and intensity better.
 

wee9bar

Member
this may aswel b pointless :( i lokked in my plants after taking the 3 plants out of 1big pot to 3pots plus adding 2more lights 2 male 3 reflector lamps and 4 those who didnt no i already had been doin 12/12 since the first week of veg an this is wat they looked like b4IMAG0096.jpgIMAG0099.jpgIMAG0094.jpg

and this is after :( i even moved lights up so it wudnt dry out r burn them

IMAG0115.jpgIMAG0113.jpgIMAG0114.jpgIMAG0116.jpg
 

wee9bar

Member
i like the way u said found,,,,, lol,,,,, done a quick research on a high bay light they r the guts off £555$ not very cheap unless its 4 a car then its £7,,,,$9.72 what sort of u using an does it give off alot of heat cause im growing in 30cm wide box thats 3foot high,, well thats the inside measurments

wee9bar , i'm also cheap this is what i use ,its a high bay light i found that i converted for my grow, the girls they love good light :blsmoke:
 
Top