Titan Ebb&Flo 1200w indoor

toaster struedel

toaster struedel

Well-Known Member
You ph should be between 5.5 and 5.9. I use 40 gal in my Rez too, for veg I use 200ml micro,grow and bloom, also calmag,silica and hydroguard. In flower I use 200ml micro,400ml bloom,200ml liquid kool bloom,40ml Floralicious plus.
 
Honda9898

Honda9898

Active Member
Think it's the lighting. The lights make the leaves looks yellow, when lights off they super Dark Green! Lol. Using tap water at moment until I can afford a RO filteration. I think it was ph and high nutes. They seem to be doing fine, I just really have to watch my ph, it jumps up so quickly... pissing me off actually cause I hate having to put ph down in everyday.. I can ph down to 5's. Then by the next day it high 6's.
 
projectinfo

projectinfo

Well-Known Member
Well hydro isnt a miricle solution. Ots a bit faster. But ive seen side by side comparisons to soil and it might be a bit faster, bit more flowers, little bit bushier. The big fenefit is having more control over your water/salt buildup/nutrients and plants react sooner in hydro so you can diagnose and correct sooner.

Sorry its not everything you hoped for but. If you keep at it i think youll enjoy the results.
 
drgreentm

drgreentm

Well-Known Member
Plants look decent man, used the flo and gro for years with good results. I was pulling 4 off 2 1ks in a 4x8 room with 6 plants consistently. I would recommend pulling your res and control bucket from your room to keep light and heat away.
 
Honda9898

Honda9898

Active Member
Well 5 males pulled out of 8.. Curious on 3 plant yield is like, we shall find out. Sounds legit, I'll have to get some more hosing and route it into the next room.
 
Honda9898

Honda9898

Active Member
I let my plants get a little too tall, gunna bend one and tie it down or eventually it will get to close to light when the light is fully maxed to ceiling.
 
drgreentm

drgreentm

Well-Known Member
I would cover those extra buckets with something. I liked my pots elevated a little above the control bucket and I put a air stone in each bucket just for added measure to oxegenate any water left in the sites. All these store bought systems work well imo with a few tweaks. Your plants look good though I would see what happens with this one and make a few adjustments on the next. Starting from clone is much easier for sure.

Few pics of one of my last grows with the titan. 2 1ks, 4x8 room, 6 plants.
 

Attachments

Honda9898

Honda9898

Active Member
Day 13 flower. 3 plants.
Seem to be doing decent. Lots of tops of all different sizes. Anchoring some of the bigger branches down a little. Hoping for a lb.

IMG_1208.PNG IMG_1207.PNG
 
eekje

eekje

Well-Known Member
hey there nice grow you got going on..i just have a few quesitons.
I see the big blue container where your solution is sitting in is located in the growroom not covered with mylar or even tin foil to avoid warming up of the solution. Do you measure temps of your solution? Be aware that high solution temps can cause root rot! An aquarium chiller for your tank won't be a bad investment for the future! ;)
 
You must log in or register to reply here.
Top