Wastei
Well-Known Member
Yes it's HPA running at 110-140 psi. I had problems with the return piping which I didn't get low enough starting out and resulted in stagnant water in the bottom of the chambers. That and electrical problems, had to modify the relay board with industrial classed relays intended for longer on intervals and 24V DC and up(operated by magnetism instead of mechanical).Hey! Sorry to dig out this thread, but as you are the guy currently helping me with my irrigation problem and who already has experience with aeroponics I thought I'm just gonna ask here because I'm also trying to set it up. Should my irrigation problems continue, I will probably switch sooner than later.
So this build is a recirculating aeroponics build. I didn't go through the whole history so apologies, if it's already mentioned couple times, but this is a high pressure aeroponics with pressure coming from the nutrient feed line, right?
Did you experience any problems when starting? Was recirculation a problem at some point? All I see is people recommending drain to waste for aeroponics.
Any pointers or comments are greatly appreciated.
I didn't have much other problems other than the learning curve of using and optimizing the system operation like the best way to do res changes and best way to bleed and re-pressurising the system.
Last edited: