Wastei's Twisted 'n Misted Girls
- Thread starter Wastei
- Start date
Absorber
Well-Known Member
Scrog on
Wastei
Well-Known Member
Thanks bud! They are getting close to flower. Getting to the point where I have to move them around every day to not cover each other or lean against the walls. I'll probably raise some of them before entering flower to get better coverage and better steering of the moisture from the humidifier.
33 days from sprout. I will probably only let them go for another week before flip. That leaves some time for the stoutest ones to have shoots to take cuttings from.
They keep increasing rate of growth and absolutely eats like hogs, real hybrid vigour. Creds to old Zenseeds for breeding her and CPH Seeds for keeping her alive and backcrossing her further while keeping vigour.
Cheers!
MissinThe90’sStrains
Well-Known Member
Wow, that happened pretty fast
Wastei
Well-Known Member
They are vigorous for sure! Especially the two pairs. I need to put the lower ones on stilts and raise the scrog net to make room in the upcoming days.
The LED been set to 370w for the last month and I will keep it there for all stretch. I'm suspecting the biggest two are gonna really stretch and will need to be cropped after stretch is done. It's gonna be a challenge to even them out gor sure!
Being fed 0.8 EC pH 6.5, pH has been stabilized in the last week and I will start monitor pH and EC runoff entering flower. I've checked it sporadically and they've been eating like hogs in veg!
Cheers!
Last edited:
Wastei
Well-Known Member
Filling out! I've added another feeding yesterday and feedings are as follows:
16:00
19:00
22:00
01:00
08:30
Pump on time is 20 seconds for every feeding. I didn't get enough runoff on the biggest two so I added another feeding. They absolutely reeks early on in veg! Taking cuttings of each tomorrow!
Cheers!
Rocket Soul
Well-Known Member
Looking very healthy
Wastei
Well-Known Member
Thanks bud! They are coming along. Very vigorous growth on two of the specimens so far! Already really loud compared to last run. I need to elevate the stoutest one in the upper left corner.Looking very healthy
Cheers!
Wastei
Well-Known Member
Got some things to fix during Easter holiday.
The humidity sensor broke and 100% humidity for a day or so causing droplets or rain falling from the roof of the tent down to one of the rails and trace/cable to the contact is corroded/broken. I opened one of the side one the contact end and water poured out... I've ordered two new sensors for the Inkbird.
All the rails and drivers work so should be an easier fix but it's a hassle to get the fixture down for repair. Luckily I have one identical I can replace it with while repairing.
Plants are doing fine all things considered, no humidity sensor and one less rail on the light. Doesn't matter this early on. Only giving them about 350w this early on.
Cheers!
sorry for the pun 
lucky its all fixable