When do you actually start LST??

Miacchi

Member
I picked up a cheap EC meter on Amazon for $15. Does the job. I use my expensive Bluelab Truncheon normally but the cheap meter works if needed for something quick. Just be careful those ones aren't water proof lol.
Hello sir, so i got the PH and also TDS ppm meter.
WELL, i was horrified as it turns out I've been overfeeding it at almost 300ppm lol since very young seedling.
And also ph at 6.7.....

What ppm should i stick to for young ones?
I saw somewhere between 150-200ppm is good? But that was for small seedling.
Thank you for advices
 
Last edited:

twentyeight.threefive

Well-Known Member
Hello sir, so i got the PH and also TDS ppm meter.
WELL, i was horrified as it turns out I've been overfeeding it at almost 300ppm lol since very young seedling.
And also ph at 6.7.....

What ppm should i stick to for young ones?
I saw somewhere between 150-200ppm is good? But that was for small seedling.
Thank you for advices
300ppm is only 0.6 EC so that's not too bad at all. I start my seeds at 0.4 EC and work them upwards. My seedlings are just over 2 weeks old and they are being fed 1.0 EC or 500ppm. They seem to be handling it well. I think they may like a slightly higher pH than 5.8 though and I've been experimenting with a pH of about 6.0-6.1.
 

Miacchi

Member
300ppm is only 0.6 EC so that's not too bad at all. I start my seeds at 0.4 EC and work them upwards. My seedlings are just over 2 weeks old and they are being fed 1.0 EC or 500ppm. They seem to be handling it well. I think they may like a slightly higher pH than 5.8 though and I've been experimenting with a pH of about 6.0-6.1.
Thank youu..
My PH was way over, this feed i guesstimated and it was at 6.7...and i actually added more Ph down to it than normal...

Well i hope i can rectify the ph and it will recover..
M tap is at 8.3ph :wall: lol lesson learnt
 

lilmafia513

Well-Known Member
When I was using perlite in my coco it would prevent algae from growing on it. Helps keep some moisture in the coco and helps evenly distribute the feed.

Those ones fit perfectly inside my 3 gallon pots as well. They are thin flexible plastic so at harvest I have to cut them off.
I use to use something similar for hempy grows, as you, to keep the algae off the perilite
 

twentyeight.threefive

Well-Known Member
Soon as its not 110 outside and 120 in my area i'm going to do a jacks run also. Seen a few people locking in good results. Happy growing!
I had equally good results with Mega Crop 1 part. Only some of the autos I had didn't like the amounts of nitrogen they were getting and I couldn't control it.

PXL_20210104_210348782.jpg

This plant here was just a gigantic foxtail. Nothing solid on the entire plant. It could have either been shitty genetics or the excess of nitrogen that caused it. Either way I had debated binning it for a while and finally decided to chuck it after this photo.
 

The Dankstar

Well-Known Member
I read first line and saw pic :spew::) Haha.

Tragic. Shit happens every grow. I just snapped one of my decent colas trying to tuck it back under a set of string falling over. Super fun. But I some a useful seeds nice ones on way waiting for some jacks run to test them out. I'll let you know how it goes !
 

twentyeight.threefive

Well-Known Member
I read first line and saw pic :spew::) Haha.

Tragic. Shit happens every grow. I just snapped one of my decent colas trying to tuck it back under a set of string falling over. Super fun. But I some a useful seeds nice ones on way waiting for some jacks run to test them out. I'll let you know how it goes !
I can't believe you just threw up over my poor plant. :(
 
Top