When to change from CFL to HPS light?

Hi my seeds have now sprouted and are around 1 to 2 inches tall the problem is I am using a CFL bulb at the moment but can only get it around 10 inches from the plants and I am worried this will cause them to 'stretch' (my understanding is cfl bulbs need to be very close to plants). I do have a 600w HPS light but don't want to burn/kill the small plants this early on. Any feedback would be great. ✌

I don't think CFLs do anything past a few inches.

Just get your CFL closer, or you will get a lanky far spaced node plant that will have bud sites far apart...

I have my 400w MH/HPS about a foot above my plants but I also hang my temp probe right at the plant tops. As long as the temp isn't too high then you're all good.

SaucyAussie said:

I have my 400w MH/HPS about a foot above my plants but I also hang my temp probe right at the plant tops. As long as the temp isn't too high then you're all good.

Click to expand...

Even with the plants wing so small at the moment? Never grown from seed before so about unsure?

Sand4x105 said:

Just get your CFL closer, or you will get a lanky far spaced node plant that will have bud sites far apart...

Click to expand...

Unable to get them any closer due to grow room set up didn't plan to grow from seeds or use CFL.
Think I am going to give them another days growth then switch it to my 600w.

That's the ticket. The sooner you get the 600 on them the better. They'll be ok. I like to keep a fan blowing between the light and the plants. If you have a thermometer you can place by the canopy that's perfect, otherwise use the back of your hand. If it gets too hot after several seconds, raise the light or increase airflow.

Lo Budget said:

That's the ticket. The sooner you get the 600 on them the better. They'll be ok. I like to keep a fan blowing between the light and the plants. If you have a thermometer you can place by the canopy that's perfect, otherwise use the back of your hand. If it gets too hot after several seconds, raise the light or increase airflow.

Click to expand...

That's perfect thank you I have all of what u mentioned as its the method I use for when I pot cuttings but was a bit unsure with such small plants.
Thanks for the advise.

You can use a 600w from day one if you wish. Didn't do my seeds any harm.

Raindancekid said:

Even with the plants wing so small at the moment? Never grown from seed before so about unsure?

Click to expand...

Sure, it's not about the type or even the amount of light but the temperature. I put mine directly under a MH after planting the sprouted seeds.

Thanks everyone gonna make the switch back to my HPS tomorrow. Thanks for your time and advise. ✌

You might notice them tak a week or so to get used to the hps...this happens from switch from mh to hps too and I know some who just veg and frloer with hps for this reason.