GanjaGreg.
Well-Known Member
I don’t know what this is and I don’t really know how to describe it but there’s a section of two of my fan leaves that are white-ish?! And also a few spots where the leaves look almost hollow?
White build up. Not spider mites, not white powdery mildew
- Thread starter GanjaGreg.
- Start date
3rd Monkey
Well-Known Member
Everything looks purple. I don't see any white.
GanjaGreg.
Well-Known Member
So first pic, you can see the bottom left is normal you can see the little hairs or w/e on the leaves lol normal, on the right the look almost singed maybe??
GanjaGreg.
Well-Known Member
GanjaGreg.
Well-Known Member
Ok so I’m looking at the bottom right of the middle leaf in the top picture and the bottom right of the far right leaf on the second picture
3rd Monkey
Well-Known Member
Much gooder lol.
That's variegation. Nothing to worry about, but does look like you need to bump humidity. Skunk genetics?
That's variegation. Nothing to worry about, but does look like you need to bump humidity. Skunk genetics?
GanjaGreg.
Well-Known Member
I forgot to use plant tags and I mixed up my seeds lol! One is a green crack, and the other is platinum og
GanjaGreg.
Well-Known Member
But I also have two pineapple chunks that are just starting out, and ya I need to up my humidity for sure.. any cheaper ways than buying a humidifier?
3rd Monkey
Well-Known Member
You can label them now. That's the GC. They must have redone the Skunk line over the past decade. Lots of skunk lineage throwing variegation.
Looks good, just bump humidity.
3rd Monkey
Well-Known Member
I have a 4x10 room. I use a $25 vaporizer from Amazon. Does a hell of a job. Can you swing that?
GanjaGreg.
Well-Known Member
Which one??
GanjaGreg.
Well-Known Member
Ya I can spare 25$ If I must lol. I just spent 300 yesterday on a nite program,tds meter , some 7 gallon smart pots, and a new led
3rd Monkey
Well-Known Member
The left is the GC.
Did you buy that blurple or a different one?
Did you buy that blurple or a different one?
Last edited:
GanjaGreg.
Well-Known Member
The smaller one has been a mutation since it popped! First the seed case was stuck on it causing one of the first true leaves to be different sizes, then it went from cotyledon, first true leaves, to five leaf fan leaf which I’ve never seen before lol. She’s small but the growth is denser. No I didn’t buy another blurple I’ve had this one for a while.. I don’t know how much of an upgrade I made with the mars hydro ts1000. It’s 150watts and supposed to be there quantum board.
3rd Monkey
Well-Known Member
Never used the Mars, but they seem to do alright. Better than blurples lol.
All your plants look fine (even with the white shit plastered on the left one lol), just a little dry. Mutations happen. Breeders are getting very sloppy these days, breeding for favorable traits and not stabilizing to remove the undesirable.
GanjaGreg.
Well-Known Member
So I actually found this at my house it’s definitely working less than minute I’m up from 29% to 36% rh. When I found it though it had salts in it? Are these harmful I rinsed it several times w hot water and a little dish soap
GanjaGreg.
Well-Known Member
Okay next question, I ran two full cycles on the humidifier and the humidity got to about 60%. Less than 10mins it’s back in the 30s... it’s a bit raised since Before the last from about 29-35. But I want to maintain at least 40% thanks for all your input
3rd Monkey
Well-Known Member
The "salts" were probably just mineral sediment from tap water.
You need to put it in the tent and close the tent. Keeping the tent open is just going to defeat the purpose of the humidity is low outside the tent.
GanjaGreg.
Well-Known Member
@3rd Monkey .My man 
HashBucket
Well-Known Member
I see just the very beginning of nute burn. The blistering, and curling of the edges.
Do ONE day of clear water, then reduce your nutes by 10% ppm.
Do ONE day of clear water, then reduce your nutes by 10% ppm.