White Poison - 2 liter Hempy SOG
- Thread starter Xare
- Start date
Xare
Well-Known Member
Yea I have reused my media once before.
I shook the rootball free of the media and gave it a rinse. But its pretty much impossible to remove all the little bits of roots.
It seemed to work ok and I may try it again in the future.
Right now iam growing a tomato plant on my deck in a 5 gallon hempy using some old media. Its 6 feet tall.
I shook the rootball free of the media and gave it a rinse. But its pretty much impossible to remove all the little bits of roots.
It seemed to work ok and I may try it again in the future.
Right now iam growing a tomato plant on my deck in a 5 gallon hempy using some old media. Its 6 feet tall.
Xare
Well-Known Member
The same reason why iam not growing in an ebb and flow table or a Aero-NFT setup.
Height restrictions in my grow space.
I do not have the room to grow larger plants. I only have room to do a SOG
And hempys allow me to grow with a very low profile.
My large plants are done outside.
If I wanted to grow bigger plants inside and get the same yield as my SOG in the same amount of time. I would need to have double the height in my flower chamber and a veg room that is double the height and size that it is now with twice the amount of veg lighting.
Vegging them up to size would take twice as long.
notoriousb
Well-Known Member
great work 
littlegrower2004
Well-Known Member
cant wait to see the final weight on this one xare! hows it looking for the next grow?
littlegrower2004
Well-Known Member
its hard to say how it will turn out without knowing how dense it is but it looks pretty nuggety so im going to go with somewhere between 12-13 oz. very good run either way and i would be extremely proud to get a grow like this under my belt.
Xare
Well-Known Member
I just put these on 12/12
They are 7-8 inches tall.
I didnt take budshots at harvest, my fingers were just too sticky from pulling the leaves off.
So instead here are some drying budshots.
A bit shaggy, they will get a final trim when I take them off the stem. And my next project is a DIY trimmer powered with a 1/2 horsepower motor.
They are 7-8 inches tall.
I didnt take budshots at harvest, my fingers were just too sticky from pulling the leaves off.
So instead here are some drying budshots.
A bit shaggy, they will get a final trim when I take them off the stem. And my next project is a DIY trimmer powered with a 1/2 horsepower motor.
