jijiandfarmgang
Well-Known Member
Buy a double pole single throw breaker and you won't have to worry about this. I assume thats what you were going to do anyway.
- Jiji
P.S. I'm not an electrician, so don't listen to me
Wiring a lighting controller
- Thread starter rekoj0916
- Start date
Buy a double pole single throw breaker and you won't have to worry about this. I assume thats what you were going to do anyway.
- Jiji
P.S. I'm not an electrician, so don't listen to me
nobody important
Active Member
Never ran into a double pole breaker that slid on the same busbar. Am I missing something? Have to ask being that I was an electrician and AC tech for over 4 years.
nobody important
Active Member
even if he used 2 single poles, all he would have to do is cut a piece off of the copper wire(12 gauge works best) to slide it in the holes that are on the breaker switch. This would link both of your single poles and would almost make it impossible to only turn one on. Just dont skip any spaces if doing this. Make sure they are touching being that the busbar alternates spacesBuy a double pole single throw breaker and you won't have to worry about this. I assume thats what you were going to do anyway.
- Jiji
P.S. I'm not an electrician, so don't listen to me
legallyflying
Well-Known Member
Fuck the breaker dude just wrap your wires around the bus bar or the main feeds coming into the house
Hey dI'd you know that if you run 240 you will use half the amount of electricity!! Has to be my all time favorite dumb as stoner remark
Hey dI'd you know that if you run 240 you will use half the amount of electricity!! Has to be my all time favorite dumb as stoner remark
Getgrowingson
Well-Known Member
Old Shit box ones will allow it. The ones in training actually allowed it lol
rekoj0916
Well-Known Member
Buy a double pole single throw breaker and you won't have to worry about this. I assume thats what you were going to do anyway.
- Jiji
P.S. I'm not an electrician, so don't listen to me
Ya'll did start to confuse me with all the extra dialogue, just want to make sure I'm understanding everything correctly. I had planned on adding this double pole breaker as it matches the rest that are currently in my main panel...
As mentioned before it is 50A, does this seem to be what you had in mind jiji? Thanks again,
Rekoj
