World Of Hempy

avnewb

Well-Known Member
Ya 2gal per is prob close to right. Watered again last night and used up over 22 gallons in 13 buckets. Used over 60 grams of Jacks Citrus so even with a whole new 1.5lb tub left that will only last 10 more waterings with is less than a month. Thats not including the 8 others that will start to need more and more water as they get bigger. Not bad for $10 but I am going to need to buy more.

Some were way too dry so need to start doing it every 3 days or less. Currently It takes me way too long to water so going to build reservoirs with drain hoses that I can water from. Should cut down on time significantly once I figure it out.

 

Growdict

Well-Known Member
I love how accurate you can be with this system. I put in 11 litres and 7.3 came out after 2 hours. In was 5.9 and 590. Out was 6.3 and 810. Using mokoko brand which comes with buffer and tea. Plants are loving it but i will try to lower the ph over the next few feedings. Next feeding will be 300ppm 5.6ph at 5 litres
 

avnewb

Well-Known Member
That seems crazy low but IDK. I have been doing 5.8 with jacks citrus at ~440ppm on tap/RO mix that is ~100ppm. I was going to start to raise it but not sure.

I setup two 27g bins to water from so that should save me hours








 

WattSaver

Well-Known Member
Kinda dropped the ball on updates for the last grow. Everything went well except for the clones of the Purple Heroin (which looked and smelt sooooo, good) were from a hermie plant so guess what a clone of a hermie brings,,,,, yes you are correct, another hermie. The PH were in back and the seeding on the Bay-11 seems to be light and not mature. I had a green pheno of the bay 11 and a purple one. Here's a shot of the purp right after trim.

17-03-08 bay11purp chop.crop.jpg

Gonna throw out the PH mother bush I saved (sure its a hermie also)
For the next grow I've got 6 un-sexed Granddaddy Purples in the veg box they will need at least 3wks before flower.
 

gr865

Well-Known Member
Kinda dropped the ball on updates for the last grow. Everything went well except for the clones of the Purple Heroin (which looked and smelt sooooo, good) were from a hermie plant so guess what a clone of a hermie brings,,,,, yes you are correct, another hermie. The PH were in back and the seeding on the Bay-11 seems to be light and not mature. I had a green pheno of the bay 11 and a purple one. Here's a shot of the purp right after trim.

View attachment 3905022

Gonna throw out the PH mother bush I saved (sure its a hermie also)
For the next grow I've got 6 un-sexed Granddaddy Purples in the veg box they will need at least 3wks before flower.
Nice looking branch there my friend. What was the total weight? GD purp is on my list. Got some G13 I want to give a shot at next though.
Stop by and see what I have going on now,

GR
 

WattSaver

Well-Known Member
Nice looking branch there my friend. What was the total weight? GD purp is on my list. Got some G13 I want to give a shot at next though.
Stop by and see what I have going on now,

GR
Just a guesstamate on the weights based on jar space usage, The 2 Bay-11 combined I got about 3oz of smokable nugs and 3oz of larff. The 2 PH are a solid 6+ oz the buds were much aireyer, then again it has some seed weight so it may be more.
 

Stomper420

Active Member
Guess I'll run a batch of hempy.. can't I use fab pots, with the drip pan as my res. Pretty mutch the same thing, why or why not
 

Growdict

Well-Known Member
i dont think it works like that. you need runoff with both types, but i suppose if you emptied your drip pan after watering, then added fresh res of 1-2" to drip pan, it would sort of be a SIP/hempy combo. you will probably do better to just feed more often in a fabiic pot and add res in your drip pan if you need to go away for a few days.
 

WattSaver

Well-Known Member
Guess I'll run a batch of hempy.. can't I use fab pots, with the drip pan as my res. Pretty mutch the same thing, why or why not
Years back I tried a fabric hempy (cut bottom 2" off a 5gal bucket and a 3gal fabric fit tight in it) It was a side by side run with 2 each fabric and hard sided with clones. The hard sided out preformed the fabric by a very noticeable margin. Don't know why for sure, but never ran the fabric again. That grow is in this thread many many pages back.
 

Roger A. Shrubber

Well-Known Member
i run hempy buckets with 60% perlite, 20% coco, 20% promix. they work great, i usually water them every other day, and the coco and promix will retain enough moisture that i can go up to four days without watering with no problems if i have to for some reason
 

tr00thz

Active Member
Does anyone else do 100% perlite? and if so- did you notice any difference when changing up the medium? I'm currently going 100% perlite for my second go around and I have absolutely no complaints thus far.
 

jmcdaniel0

Well-Known Member
Hello Fellow Green thumbs,

I have been doing soil grows for a long time. So far I have had mostly good luck, and just the few bumps all of us growers go through.

I live in the middle of nowhere, and decent soil is hard to find, not to mention the amendments needed, I was thinking about switching to Hempy style. I have been reading up on it and it really seems like a much easier way to go. I have several bags of hydroton (clay pellets) laying around for my aquaponics set up, would I be able to use that effectively instead of perlite. I can get perlite from Lowes, the next time I am in town, but I would rather save the money if I don't need to spend it.

Also,

I grow Autos mostly, since I only have the one tent right now. The packet of Beans I have right now is Heavyweights, Fast and Fast, What size pot would be recommended. I have 5 gal grow bags right now. I have several 2.5 gallon pots laying about would that be big enough?

I am toying with the idea of using a large rubbermaid tote like this.

http://www.homedepot.com/p/Rubbermaid-54-Gal-42-1-2-in-x-21-1-2-in-x-18-3-5-in-Hi-Top-Storage-Tote-FG3A05H2MICBL/100673965

I am thinking of filling about half way with the clay pellets or so, and drilling a quarter inch or so hole in there and running some pvc pipe to a collection vessel.

Any reason that wouldnt work? Also, Ill have to order some nutes, I am out of those either way. What would you recommend?
 
Top