Quick question

nl5xsk1

Well-Known Member
Scrubber up to ceiling, straight to air cooled hood, straight to fan and out. Also recommend a small input fan (lower corner)
 

nomofatum

Well-Known Member
If you care at all about costs/efficiency don't oversize much if exhausting outdoors. It will cost you greatly on your heating/cooling bill. You will want to run at minimum speed required for keeping your temp and RH.
 

Hugo Phurst

Well-Known Member
Always attach the filter to the input of the fan. That way you only have to worry about one joint being air-tight, the flange connecting the filter and fan. If you do it differently you run the real risk of venting the grow room smell out your ehaust.
 

kiwipaulie

Well-Known Member
Always attach the filter to the input of the fan. That way you only have to worry about one joint being air-tight, the flange connecting the filter and fan. If you do it differently you run the real risk of venting the grow room smell out your ehaust.
That's a bloody good point
 

kiwipaulie

Well-Known Member
Extra heat, bloddy good point there too.
or another way I used to do it, was to have a completely different fan that's ducted from outside the tent, drawing cold air over the bulb and then duct it out the side and out of the grow room area.
 

moondance

Well-Known Member
my 2 cents - loose the cool tube, go bare bulb, fan blowing on bulb, suction out the tent to filter, cool air intake in front of tent. I like to keep anything that doesn't like heat and humidity outside of my tent. MD
 

Silky Shagsalot

Well-Known Member
For efficiency, its better to pull air, and never had a fan go out from exhausting lights.
i had a shop owner tell me something once about fans. said, "think of it as a chain. you pull the chain, it follows, no problem. you push the chain, things are a bit different." i have a fan for my filter, and a diff. one for my hood.
 

moondance

Well-Known Member
I run at 79 18hrs strong right now cause I'm growing up homemade ladders. I pull air from the top of my bulb out the tent through the fan out a 6' run to the filter where it exhausts cooled air over the top of my veg area.
 

weedenhanced

Well-Known Member
my 2 cents - loose the cool tube, go bare bulb, fan blowing on bulb, suction out the tent to filter, cool air intake in front of tent. I like to keep anything that doesn't like heat and humidity outside of my tent. MD
I don't like this idea I had trouble keeping a 400w bulb cool with a wing setup bare bulb
Second I live in australia and the climate is hot there in no cool air to bring in unless I make it aircon
Electricity in aus is about 22 cents a kW
 

mo841

Well-Known Member
my buddy had a hot bedroom in his upstairs. we had the fan pulling air from the room to the outside. it stayed pretty hot up there. we turned the fan so the cool air blew in and it made a huge differance. this leads me to believe blowing air threw the hood rather than pulling it threw is the way to go.
 
Top