Ok then I'll give it a shot. Making a fresh batch today. I have four 1 oz blue spray bottles left over from the TM. I'll filter this stuff and fill 'em up.
Yea. i would definitely give it a shot before tossing it. If everythign else went well, it should work just fine. I personally refer lower ppm solutions because you can spray the entire plant, and spray more often, without burning the leaves, which gives it more "wet time" on the plant, for it to soak in. When you only spray once a day with stronger stuff, and the water dries up, more silver probably just sits on the plant surface,
I'd also definitely look into a cheap air pump and stone. It makes a big difference in being able to get higher ppm, while still generating very small particles. It also helps the solution remain clear for a long time after being made, and cuts down the amount of times that you have to wipe the electrodes during the generating process, because the bubbles help slow down the buildup around them.
You should post a picture of your CS in a clear glass jar if you can for future reference/comparison, as well as a report on how it worked.
@tekdc911 you too.
Man - I'm happy bud busy this round.
1. Making some homebrew.
2. Making CS
3. AKR ready to mist in a week or so with the CS. Just straight AKR fem seeds.
4. Two Berry Ryders about two weeks into flower.
5. One photo COC 12/12 fs. Almost done.
6. Just chopped another COC - currently toking.
7. One Berry Ryder dropping pollen. Will be dusting that on another AKR in 2-3 weeks to make the BKRs.
8. The above Berry Ryder dropping pollen will also dry hump itself and give me fem seeds.
9. Will be starting some Sour60 regs - making fem seeds.
10. Watching that 3 leaved AKR. It's growing ok just funky.
I think I missed another AKR under there.
All of this under a 600hps on 12/12 minus the pollen dropping Berry Ryder which is in a cab by itself far away. As soon as that COC fs is finished, I'll bump the lights up to 20/4 as everything will be an auto.
Time for a white board in the grow room.
You posted this while I was typing up my reply. Awesome! You have a lot on your plate.
Is this AKR that you are going to self, one of the f1's you made from selfing the breeder pack AKR seeds?
I have a Ford 8N. I was mowing the back 40 last week and noticed a tinging sound. Put my head down there and noticed the fan by the radiator was slightly hitting the shroud. Then I peak over to look where the fan is bolted to the engine and notice a leak. The fan itself is slightly wobbly. I need to do some more googling, but so far I believe it's a water pump.
they were some bad asses back in the day lol