The UK Growers Thread!

R1b3n4

R1b3n4

Well-Known Member
zeddd said:
I wish I was a yank tbh then I could own an ar15 and go shooting the shit out of trees and bears and such
Click to expand...
thats like saying you wish you had been born retarded or with only 1 arm lol

if you want an ar-15 just buy one lol
 
Last edited:
WisdomFarmer

WisdomFarmer

Well-Known Member
I got two fems out of 2 seeds, Jack the Ripper it's about 5 ft now 3 weeks 12/12, from about half way up the main trunk has grown thick & flat ,as opposed to round ! , loads of bud sites all over it , & a big fuck off clump of bud at the very end .
 
ninja1

ninja1

Well-Known Member
Morning people hows it going? more skint than I've been in a long time at the moment and fucking crop due down in a month looks beyond a joke lol. Fucking drives me mad, nute burnt 1 girl really bad and the rest a little bit. Guessing the cheap ec pen is cheap for a reason. Got 6 bodhi in their first pots looking ok nothing special but the lovedawg is stinking to fuck never run chemdawg but heard thats a smelly strain so guessing its that coming through.
 
Merlot

Merlot

Well-Known Member
Gotta take my chainsaw n strimmer into the shop today. Ran the fuckers on lean fuel, now they refuse to start :wall: hope the engines ain't blown, else that's a grand down the bog.
 
R1b3n4

R1b3n4

Well-Known Member
Merlot said:
Gotta take my chainsaw n strimmer into the shop today. Ran the fuckers on lean fuel, now they refuse to start :wall: hope the engines ain't blown, else that's a grand down the bog.
Click to expand...
take the plug out n squirt some wd40 in there,leave for 5mins n then try starting it, will rev its head off for 30secs or so but it shold start, if it dont then its probably seized, does the engine turn over when you pull the pullcord?
 
Merlot

Merlot

Well-Known Member
Nah. The strimmer been acting up for a while anyway. It wouldn't idle, and it was a bitch to get going (10-20 pulls on choke). I took it to the shop and all he did was turn the screw half a turn and claim it was fixed (didn't charge though). It ran for 10 mins then died. Not started since. The saw pretty much started doing the same (not idling, spluttering). I forced started it (pulling cord and throttle at same time) but after a while it too just refused to start. Seized is better then blown though!! If it's fixable he'll sort it. He's good, but you pay through the nose for it.

Lesson learned...measure fuel mix correctly and not by eye.
 
R1b3n4

R1b3n4

Well-Known Member
Merlot said:
Nah. The strimmer been acting up for a while anyway. It wouldn't idle, and it was a bitch to get going (10-20 pulls on choke). I took it to the shop and all he did was turn the screw half a turn and claim it was fixed (didn't charge though). It ran for 10 mins then died. Not started since. The saw pretty much started doing the same (not idling, spluttering). I forced started it (pulling cord and throttle at same time) but after a while it too just refused to start. Seized is better then blown though!! If it's fixable he'll sort it. He's good, but you pay through the nose for it.

Lesson learned...measure fuel mix correctly and not by eye.
Click to expand...
almost sounds like shit in the fuel line/filter, have you tried blowing thru the fuel line n changing the filter? should be an inline one like this somewhere
also most strimmers etc run on a mix of either 25:1 or 50:1 on the oil/fuel mix, also if you have been using cheap 2 stroke oil that can sometimes gunge it up
 
You must log in or register to reply here.
Top