DIY with Quantum Boards

delstele

Well-Known Member
Sent HLG a email about a QB 40 flickering not a word back yet... I think the driver is taking a shit gets bright for a second or two then dims quite a bit. Gets quite annoying working cutting clones all the flickering..lol
 

Frank Nitty

Well-Known Member
Sent HLG a email about a QB 40 flickering not a word back yet... I think the driver is taking a shit gets bright for a second or two then dims quite a bit. Gets quite annoying working cutting clones all the flickering..lol
Gotta have patience,something that i dont have much of lately...
 

ANC

Well-Known Member
Sent HLG a email about a QB 40 flickering not a word back yet... I think the driver is taking a shit gets bright for a second or two then dims quite a bit. Gets quite annoying working cutting clones all the flickering..lol
Yeah, the occasional driver will do that.
I'm sure they will sort you out in no time... the drivers have a pretty long warranty from the factory.
 

maxlev

Well-Known Member
Sent HLG a email about a QB 40 flickering not a word back yet... I think the driver is taking a shit gets bright for a second or two then dims quite a bit. Gets quite annoying working cutting clones all the flickering..lol
Your email will be one of the 1000 a day they have to sift through
They been really busy dealing with it all and the constant nipple reconstruction surgery probably doesn't help much.
 

TerpyTyrone

Well-Known Member
How much did the light cost to put together...
The 3500k are tough to get your hands on. Usually sold out. In 3000k or 4000k.
4 Qb132's to my door with shipping 147$ the 132s can go up to 75 watts without a heatsink. I wouldnt advise 75 each anyway.
I run mine on a 240w1750mA so a lil over 50w a board. The driver was around 60$ shipped w/ tariffs included. 5 or 10. I forget.
I liked em so much I got 2 sets of 4!!
 

TerpyTyrone

Well-Known Member
If ya can build a rectangle out of aluminum frame 12" x 45" your in luck.
Just mount em to the frame,
wire up yhe whip to the ac side, hot, neutral, ground.
Then run your qbs in series, +,-,+,-,+,-,+,- back to driver leads. A few screws a few connectors. Easy peasy
 

Ashtray3000

New Member
I am trying too light a 4x8 tent but with financial restrictions will have too peice it together. My plan is too buy QB288 Rspec boards with heat sinks one set at a time.Ordering the drivers separate.The goal being 4 sets.Would the HLG-480H.... Be the driver I want? Second question what do the extra numbers mean HLG-480H24 HLG-48024a. Third question which one has dimming ability
 
Top