Buddernugs
Well-Known Member
Coco is so good because it holds so much air I run h202 to add even more o2 to the root Zone
can I pick your brain about drain to waste In coco??Oh and always stay in the 5.8 ph range in veg and 3 weeks after the flip keep in at 6.0
so I put abunch of pictures on there those are the issues I’ve been having lately, I’m using a top fed drain to waste with gh flora 3 series and 25 gallon res sump set up to drippers, I can’t seem to figure out the issue I fertigate three times a day run off at each event, they are in straight coco except one in coco 70/30 the one growing the fastest has the yellowest/ lime green new growth, ph seems to rise too quickly in the res, and it’s got multiple deficiencies showing as well as burn symptoms, tried upping the Ec to 1.5 which caused the yellowing of the leaves flushed and brought it back to 1.0 with 3/4 cal mag and a little less than half of 1/2 of the flora I know they don’t like high Ec with the coco and frequent feeding learned that but what’s up with the deficiencies and burn, is it inaccurate phs? How much is too much of a swing for feeds, and how can I maintain a more stable ph and what is best ph range to feed at I feel like it’s a ph issue, and with coco it self buffers back to 5.9 correct?Ya shoot
some purple reddish stems too and dark green thick leaves in some spots towards the top that all twisty and think, I use tap water but it’s only at .1 Ec, and should I switch to ppmx500 and measure like that?Ya shoot
Yes my tap is .1 Ec 70 ppm on ppm500, ph out the tap is 7.5/7.6 it is chlorine treated according to the city no calcium or mag in it, and most of there feedings there entire life was 6.3 because I didn’t know much first grow, it is drain to waste, aerated with 4 air stone active aqua pump 30 minutes on 45 off, symptoms got worse after I topped them,and they started growing pretty quick and I dialed back cal mag, to raise nutes 1.3 Ec minor burn and start of deficiencies, then fast forward another pruning but only lower leaves and nodes, installed drippers because hand feeding became a nuisance they never seemed happy at 2 feeds a day, tried upping my nutes again def don’t tolerate anything over 1.1 / 1.2 Ec, jumped to 1.5 Ec, and ran uc roots because I had a little algae build up, that caused the yellowing in between leaves that and new growth irritation, and didn’t realize how fast the ph rises in my reservoir and the ph of my run off was 6.3its always at 5.9 every time I’ve checked, even at the 6.2/6.3 feeds, the res had floated up to 6.7 over the coarse of about 30 hours I knew to expect a rise but not that quick, flushed with phd water then fed low 1/4 strength nutes half strength cal mag, .6 Ec, brought the Ec back to 1.0 and managing the ph as it floats. Never fed below 5.9 ever, 7 weeks from the day seeds touched water to germinate, 2 Frisian dew, 2 green gelato, 1 hulk berry, under 2 720 e growers choice and it’s dialedback to 60%, try to keep the roots zone around 72 degrees, canopies about 78 humidity usually around 55%, it did get mid to high 80s and high humidity a few days before i put the ac in, it was switch to flower tent under bigger lights and needing 2 of them more heat didn’t have to manage it until thenAre you 100% sure your TAP water with no filtering is .1ec??!! Bro that’s 50ppms!!!!! I’d suck a cock to get my tap water 50ppms lol if that’s really what your tap water is I bet my left nut it’s A deficiency I’d dump your Rez and give 3ml per gal of cal mag (Iv gone as much as 5ml per gal you’ll be good trust me) after you get your tap water to 300ppms with JUST cal mag bump that up to 600ppms so basically I will have 300ppm cal mag and 300ppm of feed.....I know that sounds odd and u are starving them but trust me that formula has taken me to the next level check your runoff ppms every time u feed them if it’s 100+ppms over than what’s going in your over feeding also check your ph as well
Red stems on different strains and different seed venders frisian are Dutch passion and I forget what the green gelatos and hulk berry were, someone gave them to me, run off Ec has usually been consistent to inflow except when I installed drippers and upped Ec it was like .8 lower, that was before the flush, like I said it’s my first grow but what I think is going on was a ph issue from the unmonitored up swings and never feeding them below 5.9 I think I had slight cal mag, and p issues, dialed it back too much on cal mag, nute burned them maybe locked them up and over stressed them before flush but they are absolutely still growing I can tell factually because of the net, and fairly quick but I want to flower them and don’t want it to get worse, so you’re advice is 300 ppm cal mag then add nutes about 300 ppm, I use flora series I have been using equal micro gro and bloom, should I switch the ratio of the flora series too I was thinking of upping the micro keeping the flora and lowering the gro, and how to I keep the ph more stable in the res or should I just aim for 5.8 to 6.2 daily swings and adding a little down?Red stems are hard to go by becuase they could be genetic only way to tell 100% that it’s an issue is running the same strain for a few years to full out genetics
That’s how they are doing definitely growing because I pulled the Scrog net the other day to replace the drippers and pull the tall one to its own space, and the tall one I had all the branches tied straight down now they are pointed back up and a few inches longer but idk they got some weird stuff developing, I’m trying to fix it I wanna flower them soon, and I need another trim or two along with I should fix the deficiencies before flipping them right?Ya keep it at 5.8 for mag uptake so it don’t get worse you’ll have to mess with it every day which is normal most of the time I’d stick with the micro and grow for the first 3 weeks of flip then switch to strait bloom
Yup that’s 100% mag def the twisted and deformed leafs at the tops are a dead give awayThat’s how they are doing definitely growing because I pulled the Scrog net the other day to replace the drippers and pull the tall one to its own space, and the tall one I had all the branches tied straight down now they are pointed back up and a few inches longer but idk they got some weird stuff developing, I’m trying to fix it I wanna flower them soon, and I need another trim or two along with I should fix the deficiencies before flipping them right?
I would get coco bags the coco is better balanced. I use ecothrive with added charge. Its great stuff.Thanks for your input! So when going with straight coco, you would recommend the bricks? And what About with perlite?