HOW TO GET HOMOGENEOUS BUDS SOGGING?

[Tesla1200]

Hi i'm a sog grower, actually grow in coco 72*1,65L pots in a 4x8 tent.
I'm just asking if someone use some grow training technique to get more homogeneous buds.
I just lollipop and defoliate a little bit. I leave some photo of my actual grow.

 

[Roxo]

How much more homogeneous do you want it? Lol. It's a pretty even canopy and looks great.

What's that hanging from the USB cable in the middle?

 

[spliffendz]

Throw a net on it

 

[Tesla1200]

How much more homogeneous do you want it? Lol. It's a pretty even canopy and looks great.

What's that hanging from the USB cable in the middle?

Density with 72 clones is to high, some buds does not get any light. Just asking to improve My sog skills.
They are Arduino sensors.

 

[Tesla1200]

Throw a net on it

Actually got it.

 

[spliffendz]

Do you feed through the holes directly where the branch is? Only asking as I seen someone stating on this site that a 'proper' scrog was when you feed the plant through one side of the net until you reach the other end, but I've only done the 'improper' way

 

[spliffendz]

A sog I would consider what the underground do here when they fill bedrooms with small pots and single colas I'm guessing for speed and mass

 

[Tesla1200]

Do you feed through the holes directly where the branch is? Only asking as I seen someone stating on this site that a 'proper' scrog was when you feed the plant through one side of the net until you reach the other end, but I've only done the 'improper' way

I don't understand at all your question i feed as u see in the second image. Automated watering pot by pot

 

[spliffendz]

I don't understand at all your question i feed as u see in the second image. Automated watering pot by pot

Sorry I meant do you feed the branches through the net, time for bed for me, knackered

 

[BecauseIgotHigh]

lollipop them and make a single cola branch, try not branching out. cut fan leaves in half instead of removing them.

 

[BecauseIgotHigh]

how much light are you using?

 

[Tesla1200]

lollipop them and make a single cola branch, try not branching out. cut fan leaves in half instead of removing them.

Good advices bro using 600hps and 650W LED at 80% power

 

[Blue brother]

take way more cuts than you need and only pick the best/ most homegenous looking cuts. Then remove everything apart from the last node so you only have 1 big bud per plant. Plants around the outside and in the corners will always look a little different to those getting most of the light though. Read Al b fuct thread in the hydro forum. Very homogenous grow. Once you start topping/dimming or allowing other primary tops to develop on one plant you can kiss goodbye to homogenisation

 

[Tesla1200]

take way more cuts than you need and only pick the best/ most homegenous looking cuts. Then remove everything apart from the last node so you only have 1 big bud per plant. Plants around the outside and in the corners will always look a little different to those getting most of the light though. Read Al b fuct thread in the hydro forum. Very homogenous grow. Once you start topping/dimming or allowing other primary tops to develop on one plant you can kiss goodbye to homogenisation

I never try to lollipop everything apart the last node yield Will not dicrease a lot? I Will try un My next grow. Great advice if u want to send me some link to some threat i Will be very glad yo read. Thank u friend