Biobizz feeding - autoflower

[rimjow]

Hello there

My tap water is usually at 7 / 7.3 PH and I usually drop it to 6.3 / 6.5.

Today when I did the mixture of biobizz nutes for the first timethe PH dropped to 4 or less.

What should I do? I have read to not mess with the ph of organic solutions.

I’m using biobizz light mix soil and the nutes I used for the solution was Biobizz Grow and Biobizz AlgaMic

The PH numbers I have are not exact because I don’t have a pen.

Thanks for the help!

 

[HydoDan]

You're alright got this from their website.
BioBizz Light Mix is also pre-buffered for pH and the limiting agent used in Light Mix will automatically correct any pH variations in the substrate back to the optimal level.

 

[Astral22]

With Biobizz you don't have to be too precise with pH, it's enough to just round it up at 6.5 or 7 and the microbes will take care of the rest. It could only hurt if your pH is 8-9, then you should lower it because it's not supersoil, living soil or All Mix, just a lightmix and it can only buffer so much.
But your water is perfect. I use Biobizz Light Mix and their nutes, i had issues with my tap water at 8-9 pH but when i started adjusting to 6.5 or 7 it all became better and no problems after. Also i've read somewhere that Biobizz can only lower the pH and not raise it, but don't quote me on that.

Biobizz nutes drop the pH by themselves, so you should check your pH only after you add all the nutes, mix and wait 5 mins. Then you can adjust if you want. The pH of your tap water is already good enough, so with the nutes added i'm sure it will drop to 6-6.5

 

[Bobkatar]

You're alright got this from their website.
BioBizz Light Mix is also pre-buffered for pH and the limiting agent used in Light Mix will automatically correct any pH variations in the substrate back to the optimal level.

so you dont have to do anything when you put the nuts in right ?regardless if ph is high or low ?