I posted the 'weather seal' fix before... did you try it? It works perfectly for me - and I believe I saw another fellow post the same solution after having success. Be sure your spray bar is not too high (too near the top of the lid). I run mine 8.5" OC from the bottom of the tub.1st time poster, long time reader. I noticed DirtHawker had the same problem about 200 pages back. I can't for the life of me get the top of my cloner to not accumulate water from the ez clone sprayers and eventually start dripping. Sometimes it actually pours out the sides. Anyone ever figure out a difinitive fix for this? Pics are appreciated...
peace,
juxt
Run the weather seal around the edge of the tub as shown in the photo. Be sure not to stretch it when installing - it will return to its original elasticity. The resulting shrinkage will move your seal out of position and may cause leaks. Use one piece and join at the center over the handle. Cut the rubber seal at an angle to join. I change the weather seal after two sessions. It malforms eventually and may leak. My hut has a built in liner that helps save me from disaster. Be sure the veg/cloner units sit over a water-ready surface. Accidents will happen - Elvis Costello.
Attachments
-
167.2 KB Views: 189
-
177.4 KB Views: 183