Right mate first 2 are in
Ive had a right game, i measured 5o ltrs of water, i started adding ph down a mil at a time and it was hardly moving it so after a few mil i though ill just pour some in lol, took it straight down to 2 so then i had to keep taking some out and adding normal water until i got 5.3, i then added the canna start and this took the ph down to 3.8. I started thinking my ph pen was no good but i calibrated it and it was fine. I added some more water to the liquid and got a final ph of 5.3 and an ec of 0.9.
Ill get some pics done in a sec i need a fag first. Syphon pump took forever so ended up using a jug and doing it like that.
Its been a big learning curve today, not sure why but the ph of my water seemed to hardly move at all then all of a sudden it plumets lol, not sure if this is normal. I think ill leave it to stand for a bit next time. I mean 1.5ml of ph down was only moving it 0.3 at a time then all of a sudden i added very slightly to much and it went really low. Same when i was adding tap water to raise the ph up, 6ltrs was only raising it 0.2-0.3 then all of a sudden it shot up to about 5.3.
When should i check ph and ec again mate? Im thinking of taking a small sample from one of the buckets and measuring like that because if i drop my ph pen in it will be fooked.