Search results

I will try. the pictures under "Right pot again, lower buds, showing white stuff" is the best i have so far.

Yeah that has happened to be once before, sad day..

you are talking about the smaller one right? Thank you for the advice, hopefully it will work. What to do about the white spots?

I will not be able to get to that tonight because of the light cycle. I have never tested the PH level what is the cheapest way to do so? i am not looking to spend 70 bucks just to test ph out.. and manganese or magnesium?

There are tiny little bugs that fly around. Whenever they get watered.I've used water almost every time, some store brand bought supplemental stuff for plants (2 drops per quart) only did that twice. I believe heat stress is a big factor. I hung a tiny fan that barely even does anything. When...

So i have 2 growing under a 250w hp. small closet light is about 18 inches above both seeds were germinated then put outside at the same time. After 2 weeks one started to pre flower (the short one in front) and so both were brought inside. Second one did not pre flower til a week after...

i wanted to make hash, but what would be the best way to make sure i do not get any of the mold? And thank you!

Well the bud is already curing (harvested last Wednesday) During the drying process, there was not much air circulation, and it was in a closet, so i am guessing that would be why.

Not to that magnitude, the picture was for clarification of the mold and perspective. When looking at it up close, it is hard to distinguish what is mold, and what is crystals, thats how small the "mold" is. if i smoke mold would i get affected right after i inhale or not for a few days or...

it does not look like that picture at all. It is hard to say what is "rot" and what is thc crystals.. the stem is a little brownish. ive smoked the bud 3 times, and been fine. any good way to kill it off if there is barely much of it? and it does not smell bad at all

after i picekd it, and dryed it.. i noticed web like structures.. it is mold.. looks mlike this. http://www.weedguru.com/forum/viewtopic.php?f=62&t=26935 what should i do? i dont want to toss all of it.. and its not thhatt bad. anytihng i could do? i sepreeated the oens that may have some...

not that much heat, i had it on a stove at the lowest possible temperature, (1) and made it slowly evaporate.. its not lie i am using fire and alcohol, just low heat. once i saw any "steam" coming from the pan, i lowered it.

why is it unsafe? i was pretty hapoywith the extractions. 2 years in everclear...

it worked.. but idk how safe it was

I have a bunnnch of stems, and about 2 g;s of great bud. I coved them in everclear, and let them sit.. 2 years later i forgot about the bottle. Through coffee filters, i strained it into a pain, and put the pan on low heat with a fan blowing above it. eventually the alcohol evaporated, and a...

So then what would the problem be? It is only affecting the leaves closer to the top, lower ones are fine.

o ok, i was always told to keep a 400 hps about 18-36 inches away to prevent burning, there is not much ventilation, closet cn get upto 90's

Is it low nitrogen?

I have a few pictures, The 400 hps light is about 3 ish ft from the top of the plant. is it getting too hot or what is it?