Never Known
Active Member
I’m not sure but doesn't a carbon filter help with humidity anyway? So if I set my T6 to temperature control while connected to a carbon filter humidity should decrease anyway?
Ac Infinity Fan help
- Thread starter Never Known
- Start date
TintEastwood
Well-Known Member
For me. The humidity of intake air key. Ideally near what you want in grow. Usually lower intake rh is better...vs higher.
Never Known
Active Member
Sorry what do you mean
TintEastwood
Well-Known Member
When the fan is exhausting, fresh air comes into the tent, typically thru vents down low.
Just pointing out the temperature and RH of the fresh air coming into your tent can have a huge impact on how easy or difficult to control.
Big temp and/or rh swings = powdery mildew for me
Great info for any grower.
Grow Room Atmosphere & Ventilation
Your garden is a living breathing system that needs to take in fresh air and expel waste air and heat. The atmosphere inside of your grow room is just as important than the grow light you choose.
hydrobuilder.com
CO2 Enriched Hydroponic Growing | Manic Botanix
The CO2 fertilizer effect. Article covers contemporary research about yield increases in under lights growing with CO2 enrichment. Optimum ppm and growth.
medteknutrients.com.au
GBAUTO
Well-Known Member
My T6 will. run if the temp OR humidity exceeds my set points.
I can set min. or max thresholds to get the fan to operate.
It will spool up gradually to max and then spool down as the conditions get within parameters.
Never Known
Active Member
Ahhhh I see, a few people mentioned you can only do one. How did you manage to get yours to do both
GBAUTO
Well-Known Member
My T6 will allow me to set a max OR min limit for both temp and humidity.
That means you can get it to operate if the temp or humidity is either above OR below the set point.
It won't do both(max-min) so it will run if the temps get above the set point AND it will also run if the humidity gets above the set point.
That means you can get it to operate if the temp or humidity is either above OR below the set point.
It won't do both(max-min) so it will run if the temps get above the set point AND it will also run if the humidity gets above the set point.
Similar threads
